Thanks: 16
Likes: 676
Needs Pictures: 5
Picture(s) thanks: 50
Results 16 to 30 of 477
Thread: Challenge 2020 - 2021 Simplicity
-
16th September 2020, 09:18 AM #16
Thanks Hiroller
That’s a very good point,
Unfortunately, as much as I would like to think I had come up with a dastardly plan to throw the competition off.
It’s just a crap drawing just a loose sketch,
Funny enough my father in law as a plane in his shed unfortunately he can’t remember we’re it is,
As I had asked him the other day,
So I could copy the tote !!!
Cheers Matt.
-
16th September 2020, 03:14 PM #17
It has begun !!
Cheers Matt,
-
16th September 2020, 03:32 PM #18
Matt
Could you draw an arrow to indicate where the start is please?
Regards
PaulBushmiller;
"Power tends to corrupt. Absolute power corrupts, absolutely!"
-
16th September 2020, 03:49 PM #19
-
16th September 2020, 04:45 PM #20
-
16th September 2020, 06:31 PM #21
I dunno; I feel there's something slightly furtive about using hand power tools to make a hand powered tool. Perhaps you should disguise any future angle grinder evidence with some hastily applied hacksaw marks?
Nothing succeeds like a budgie without a beak.
-
16th September 2020, 06:39 PM #22
-
16th September 2020, 07:43 PM #23
I'm sure a man of your mettle will be able to steel yourself in preparation for the task.
Nothing succeeds like a budgie without a beak.
-
18th September 2020, 09:27 PM #24
Spent some more time in the Tablecloth Design studio early this evening.
I think I’m getting close to something I like,this latest one is taking some design clues from Norris planes.
Hopefully the judges will note my head tipping to days of old, yet moving forward with some swoopy lines.
Ps : I hate using crappy pencils.
Cheers Matt.
-
19th September 2020, 04:47 PM #25
So this afternoon the design team(Me myself and I)
Progressed from a 2D table cloth design,
To a full 3D MDF Representing in-covering all the artists design requirements, yet still holding on to its MDF heritage.
I may review the centre hump location,that will hold the pin location for the Lever Cap and move that forward approximately 10.33789 mm.
Cheers Matt.
-
19th September 2020, 05:51 PM #26
-
19th September 2020, 06:21 PM #27
-
19th September 2020, 06:43 PM #28
-
19th September 2020, 06:53 PM #29
-
19th September 2020, 07:08 PM #30