Hey all,
Im building stairs, and require merbau on the ends of the stairs. However, its not a standard width. (standard being, that merbau comes in)
So anyway. I need to trim/plane/cut the width of a merbau board, but there are 7 to do @ 3m each. Maybe im being lazy but doing this by hand with merbau will be hard, and my hand cutting skills are not all that great.

Is there somewhere I can go to get this done on a table saw?...

I made a staircase in the back of merbau but was only 1M wide, so using my electric plane was no trouble, this is a bit trickier.

Cheers.

Excuse the fotos, they are bad.

Attached Thumbnails



Read the full thread at RenovateForum.com...