Results 1 to 1 of 1
-
16th November 2008, 07:10 AM #1
Brivis Networker- adding a 2nd controller!
Gday all,
I have a Brivis central heating unit in a new house with the Networker (V3) installed to the heater downstairs.
I would like to add an additional Networker upstairs and wonder would anyone shed some light on what is involved to set up the controller. I already had a 2 wire power cable running between both the heater and current Networker and the planned location of the new Networker. (Planned ahead at frame stage but didn't install a second controller because wasn't sure if I would use it!)
From the Brivis website I read that 2 controllers can be installed from the one heater running as master/ slave but gives no indication to what is involved in the setup procedure. From looking at the current networker it runs from a two wire setup from the control module on the heater unit itself but doesn't seem to have a terminal for a second controller?
Any info would be appreciated.
Cheers
Raff:U
More...
Similar Threads
-
Brivis Ducted heating problem
By futronix in forum HEATING & COOLINGReplies: 30Last Post: 28th April 2008, 10:17 PM -
Brivis ducted heating wall control Not working
By busylion in forum PLUMBINGReplies: 0Last Post: 20th April 2008, 07:39 PM
Bookmarks