Results 1 to 6 of 6
-
1st April 2008, 11:09 AM #1
New Member
- Join Date
- Apr 2008
- Location
- Warrnambool
- Posts
- 2
Why not use stud adhesive for tiled areas?
After hanging some Gyprock Aquachek last weekend according to the Gyprock pamphlet I was given by the seller, I have since found a more detailed installation guide on the Gyprock website that says stud adhesive must not be used in areas to be tiled.
I hung all my sheets using nails and stud adhesive. Do I have to rip off the sheets in the areas to be tiled and rehang using only nails? Why should stud adhesive not be used for tiled areas?
-
1st April 2008, 12:03 PM #2
1/16"
- Join Date
- Mar 2007
- Location
- Adelaide South Australia
- Posts
- 76
The instructions don't say why but I was told it was because tiled areas are usually wet areas (bathrooms) and moisture/condesation can get behind the walls causing the adhesive to let go.
Removal shouldn't be needed. Just bang in a few more nails.
Don't force it, use a bigger hammer.
Timber is what you use. Wood is what you burn.
-
1st April 2008, 12:12 PM #3
Senior Member
- Join Date
- Feb 2008
- Location
- Aust
- Posts
- 192
The bubblegum doesn't like water
Put in some Tek screws as well at 300mm centres. Forget the extra nails.Removal shouldn't be needed. Just bang in a few more nails.c2=a2+b2;
When buildings made with lime are subjected to small movements thay are more likely to develop many fine cracks than the individual large cracks which occur in stiffer cement-bound buildings. Water penetration can dissolve the 'free' lime and transport it. As the water evaporates, this lime is deposited and begins to heal the cracks. This process is called autogenous healing.
-
2nd April 2008, 08:12 AM #4
New Member
- Join Date
- Apr 2008
- Location
- Warrnambool
- Posts
- 2
Thanks very much for the responses.
Should I use screws rather than nails because they will be through the stud adhesive? I have read that as the stud adhesive shrinks it can pop out nails.
-
2nd April 2008, 09:33 AM #5
quality + reliability
- Join Date
- Jul 2006
- Location
- Melbourne
- Posts
- 675
-
2nd April 2008, 05:44 PM #6
New Member
- Join Date
- Mar 2008
- Location
- perth
- Posts
- 9
why bother tiling at all - try out the pvc internal wall cladding . waterproof , mould resistant , many designs available. even her indoors could fit it .
Reply With Quote
Similar Threads
-
Problems during stud adhesive application on battens
By kyaw19 in forum PLASTERINGReplies: 3Last Post: 14th July 2007, 01:43 PM -
squaring up large areas
By yakka in forum BRICKWORK, CONCRETING, PAVING, RENDERING, etcReplies: 26Last Post: 18th December 2006, 01:24 PM -
Filling large areas
By fcm in forum FINISHINGReplies: 3Last Post: 9th July 2001, 10:39 AM
Bookmarks