Results 1 to 7 of 7
Thread: soundproofing plumbing pipes
-
22nd March 2008, 07:00 PM #1Amateur D-I-Yer
- Join Date
- Mar 2008
- Location
- Byron Bay
- Posts
- 52
soundproofing plumbing pipes
I am having a granny flat built on the side of my brick veneer house.
The exterior brick skin has been removed along the side where the flat will be. The slab has been poured, and the frame and roof are in place.
The water pipes in the wall of my bathroom are currently exposed, because the bricks are gone. The wall will be internal now, and will be sound insulated and plastered.
I don't want pipe noise to disturb the occupants of the granny flat, and I don't want noise from the flat to enter the house.I am using polyester insulation in the cavity, and two layers of 10 mm SoundCheck plaster, with QuietWave membrane between.
Does anyone have any advice about lagging/soundproofing the pipes?
Cheers
Mark
-
23rd March 2008, 08:26 AM #2Senior Member
- Join Date
- Oct 2005
- Location
- newcastle
- Posts
- 216
treat same as for fire rated walls - ie fire rated silastic. all the brands have it, and as well as fire rated its usually accoustically rated because its much denser.
hope this helps
eg
http://www.bostik.com.au/distributio...lants_page.htm
fire ban 1 ^^^^^^
edit - another one to add that I just happened on
http://www.soundblock.com.au/pipes.htmlLast edited by pharmaboy2; 23rd March 2008 at 08:28 AM. Reason: added
-
23rd March 2008, 05:17 PM #3Intermediate Member
- Join Date
- Apr 2004
- Location
- Parkdale Vic
- Age
- 73
- Posts
- 26
Pipes
Hi, I work as a plasterer and I notice that good plumbers use a silicon sealant where the pipes travel through the joists etc. Similar to no-more-gaps. They say that it reduces hammer and vibration. May as well give it a try now that you have access to the pipes.
George
-
23rd March 2008, 07:35 PM #4
i am not sure about the pipe noise you are worried about ,is it possible water hammer ,waste water pipes , sewerage waste ,please specify so that this forums enormous wealth of knowledge can advise
-
27th March 2008, 06:01 AM #5Amateur D-I-Yer
- Join Date
- Mar 2008
- Location
- Byron Bay
- Posts
- 52
-
27th March 2008, 08:04 AM #6
if its only water pipes then silicone in all holes will stop water hammer or vibration , lagging will only add an extra cost with no real benefits added
-
27th March 2008, 03:41 PM #7Amateur D-I-Yer
- Join Date
- Mar 2008
- Location
- Byron Bay
- Posts
- 52
Similar Threads
-
Flexi-water pipes , ok for shower plumbing?
By jambo000 in forum PLUMBINGReplies: 4Last Post: 14th January 2008, 09:27 PM -
Removing roots from pipes without replacing pipes
By Williamstown in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 8Last Post: 8th October 2007, 01:27 AM -
Soundproofing a Pump
By Flyboy in forum GENERAL ODDS N SODSReplies: 8Last Post: 27th March 2006, 07:48 AM
Bookmarks