Results 1 to 13 of 13
  1. #1
    Join Date
    Mar 2008
    Location
    Gold Coast
    Posts
    3

    Default Help with Retaining Wall

    Hey guys, i am embarking on a garden makeover and have a few questions regarding a retaining wall which i would like to build.

    Fist some info the wall will be 900mm high and will be "L" shaped the longest side will be 3200mm long and the shortest 2000mm long. I am looking to use besser blocks with mortar. The wall will be used as a raised flower bed decorative.

    Now for some questions:

    1. How deep do i need to dig the footing?

    2. Will i need to use reo bars in the footing and up through the blocks?

    3. what would be the best option for drainage, leave weep holes in the base course with ag pipe and blue metal in behind the wall?

    Any other suggestions that may help me in making this wall sturdy and lasting would be much appreciated.

    cheers,

    Ben.

  2. #2
    Join Date
    Feb 2008
    Location
    Aust
    Posts
    192

    Default

    Its hard to say about the footing at that height. Often footings to suit those types of walls are heal and toe footings with at least some y12s to go up the centre of the core at least every 4th core.
    Engineers detail is always good.

    1. How deep do i need to dig the footing?
    This will depend on the type of footing

    3. what would be the best option for drainage, leave weep holes in the base course with ag pipe and blue metal in behind the wall?
    if you are in clay type soils, yes. clay or similar have poor drainage

    Go for a 6 sand : 1.5 cement: .5 lime mortar mix a little bit stiffer than brick mud so it is just workable to wipe on or slide spread.

    If the blocks are "wet" dont lay them.

    Can't find Borals Spec sheet for footing design. They have their home handyman product Connex which requires no joint mortar.

    http://www.boral.com.au/CB/products/...asonryProducts
    c2=a2+b2;
    When buildings made with lime are subjected to small movements thay are more likely to develop many fine cracks than the individual large cracks which occur in stiffer cement-bound buildings. Water penetration can dissolve the 'free' lime and transport it. As the water evaporates, this lime is deposited and begins to heal the cracks. This process is called autogenous healing.

  3. #3
    Join Date
    May 2003
    Location
    Kuranda, paradise, North Qld
    Age
    63
    Posts
    2,026

    Default

    Quote Originally Posted by Blazeit View Post
    ........
    1. How deep do i need to dig the footing?
    .............
    Depends on the soil type and footing design.


    Quote Originally Posted by Blazeit View Post
    ........
    2. Will i need to use reo bars in the footing and up through the blocks?...............
    Yes, size and spacing as specified by engineer.

    Quote Originally Posted by Blazeit View Post
    ........
    3. what would be the best option for drainage, leave weep holes in the base course with ag pipe and blue metal in behind the wall?
    ...............
    Ag pipe (with suitable fall) and blue metal (trench rock) behind the wall, covered with geo textile to stop fines clogging it all up. If possible I prefer to run the ag pipe out to a low point and drain all the water through it, rather than having unsightly weep holes.

    Quote Originally Posted by Blazeit View Post
    ........Any other suggestions that may help me in making this wall sturdy and lasting would be much appreciated...............

    Horizontal reinforcement every second course of blocks and possibly two bars in the top course. Every core filled. Back of the wall coated with a cement/silasec mixture (2 coats) and 2 coats of bituminous paint.

    Mick
    "If you need a machine today and don't buy it,

    tomorrow you will have paid for it and not have it."

    - Henry Ford 1938

  4. #4
    Join Date
    Mar 2008
    Location
    Gold Coast
    Posts
    3

    Default More detail

    hey guys thanks for the input, the ground is a clay makeup and the footing will be poured concrete.

  5. #5
    Join Date
    May 2003
    Location
    Kuranda, paradise, North Qld
    Age
    63
    Posts
    2,026

    Default

    Footing design encompasses more than just deciding they will be of concrete, I'm afraid and there's more to soil type than just "clay". You really need to get an engineer to design the footings as they may need to be "L" shaped. Size, depth and quantities of reinforcement are all variables.

    Mick
    "If you need a machine today and don't buy it,

    tomorrow you will have paid for it and not have it."

    - Henry Ford 1938

  6. #6
    Join Date
    Jan 2004
    Location
    South of Adelaide
    Posts
    136

    Default

    Have you considered Boral Gardenwall blocks as an alternative?

    No footing to pour, can be built up to 1m high, various colours and look heaps better than Besser blocks.
    Jack

  7. #7
    Join Date
    Feb 2005
    Location
    Gold Coast
    Age
    48
    Posts
    3

    Default

    Hi Ben

    I built a besser block retaining wall about 6 months ago which was about 800mm high (4 blocks high using 200 series blocks) and roughly 18 metres in length with a zip zap shape. I was not sure what I was doing but here is what I did, hopefully it mite help you a bit!

    For the footings I made my own footing cage using "ligs" (I think that is the technical term 200mm by 200mm joined by y12 steel rods. ( I would not make these up myself again. You can get pre made footing cages for a little bit extra, but lessoned learned!). I also had the starter bars which I had going in every second block hole.

    I laid the first 3 layers of blocks then added a horizontal steel bar and then laid the top block over this. I used a channel block for this hoziontal bar to be inserted in.

    I then core filled the holes with the starter bars, then waterproofed the back of the wall and added gravel and ag pipe behind it.

    Maybe this was overkill but I was not sure what i was doing but it has been 6 months and so far so good.

    I found this document from hanson quite a good reference. I did not follow it precisely but gave me some ideas.

    http://www.hansonbp.biz/document_get.aspx?id=195

    Hope this helps
    Cameron

  8. #8
    Join Date
    Feb 2008
    Location
    Aust
    Posts
    192

    Default

    Have you considered Boral Gardenwall blocks as an alternative?
    What make you house look like a freeway off ramp and depreciate it $50000

    They definitely have their place. They do look alright. However I have never seen them used in around a flash house.

    Blazeit hasn't said what soil type he has yet?

    There is also concrete post and panel retainers as well which serve a purpose and look half decent.

    http://www.twinside.com.au/walls_fences_perth.htm

    All good for DYI people.
    c2=a2+b2;
    When buildings made with lime are subjected to small movements thay are more likely to develop many fine cracks than the individual large cracks which occur in stiffer cement-bound buildings. Water penetration can dissolve the 'free' lime and transport it. As the water evaporates, this lime is deposited and begins to heal the cracks. This process is called autogenous healing.

  9. #9
    Join Date
    Mar 2008
    Location
    Gold Coast
    Posts
    3

    Default

    Hey Cameron thanks for the run down what depth did you dig your footing to and was the footing L shaped or just cubed. ie.
    |-------------------------------------------|
    | side view |
    |-------------------------------------------|


    Also autogenous i'm not 100% sure of the soil type in technical terms all i know is it is of a clay makeup.


    cheers,

    Ben.

  10. #10
    Join Date
    Feb 2008
    Location
    Aust
    Posts
    192

    Default

    |-------------------------------------------|
    | side view |
    |-------------------------------------------|
    That would be a section detail of the wall...

    Clay make up is generally a little up sized due to the movement in the soil through water take up and evaporation.
    You should put drainage in at the back of the retainer as well being clay.
    An engineers section detail may save you money rather than guessing.
    he may make it very simple.
    I wouldn't say the detail will cost you a lot of money. Its worth calling and asking how much.
    c2=a2+b2;
    When buildings made with lime are subjected to small movements thay are more likely to develop many fine cracks than the individual large cracks which occur in stiffer cement-bound buildings. Water penetration can dissolve the 'free' lime and transport it. As the water evaporates, this lime is deposited and begins to heal the cracks. This process is called autogenous healing.

  11. #11
    Join Date
    Feb 2008
    Location
    nsw
    Posts
    73

    Default

    in nsw retaining walls over 300mm in height have to be designed & certified by an engineer.... but if you follow that heel and toe design someone described earlier should have no problems.. make sure you include weep holes, ag line behind wall has fall etc

  12. #12
    Join Date
    Feb 2005
    Location
    Gold Coast
    Age
    48
    Posts
    3

    Default

    [quote=Blazeit;696020]Hey Cameron thanks for the run down what depth did you dig your footing to and was the footing L shaped or just cubed. ie.
    |-------------------------------------------|
    | side view |
    |-------------------------------------------|


    Hi Ben

    The footing I dug was "cubed" and around 25-30cm deep. I think it was around 30-35cm wide. In it I had the 20cm by 20cm footing cage.


    Cheers
    Cameron

  13. #13
    Join Date
    Jan 2004
    Location
    South of Adelaide
    Posts
    136

    Default

    Surely Autogenus you cant be serious?

    There is also concrete post and panel retainers as well which serve a purpose and look half decent.

    http://www.twinside.com.au/walls_fences_perth.htm
    We use that cheap looking rubbish to line expressways as a noise barrier and somewhere for the graffiti vandals to amuse themselves. They are constantly repairing them as vandals practice their kicking and break the panels in two.
    Jack

Similar Threads

  1. Water Feature / Wall Wall - Any ideas???
    By Fr_303 in forum LANDSCAPING, GARDENING, OUTDOORS
    Replies: 34
    Last Post: 27th December 2007, 02:44 PM
  2. Help for Brick Wall
    By kyles41 in forum BRICKWORK
    Replies: 1
    Last Post: 11th April 2006, 11:01 PM
  3. Wall mount TV 'stand' onto bessa brick wall
    By burn in forum HOME THEATRES
    Replies: 18
    Last Post: 29th March 2005, 11:26 PM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •