Results 1 to 9 of 9
-
7th January 2008, 04:42 PM #1Novice
- Join Date
- Jan 2008
- Location
- melbourne
- Posts
- 12
4.5mm durasheet - ok for wet area tile?
Hi all,
I'm renovating my bathroom and being new to the country..(we don't use this stuff where i come from)...i asked my local DIY store for wet area sheets to tile on. They sent me 4.5mm durasheet , is this stuff ok for shower area tiling?
Thanks for any advice...
Jim
-
7th January 2008, 04:52 PM #2
-
7th January 2008, 09:22 PM #3
Hi there Jambo000
Normally 6mm is the go, the 4mm stuff is obviously not as tough, so if you fell agaist the tiled surface it might not stand up so well. Villaboard is anoth 6mm wet area rated product from James Hardie.
-
7th January 2008, 09:51 PM #4Novice
- Join Date
- Jan 2008
- Location
- melbourne
- Posts
- 12
Thanks for the reply's - i'm not worried too much about the strength of the board as i'll be fitted on top of plasterboard. I'm more worried about it's waterproofing abilities. When i removed the existing tiles i found them attached to the same 4.5mm board , they has been there a good few years and appeared to be fine as far as waterproofing is concerned.
-
7th January 2008, 09:54 PM #5
Hi Jim,
As the others said 6mm is the go for tiling onto. It is recess edged for flush jointing so you can tile without getting deviation in the tiles on the joint area.
Good luck
Bob
-
8th January 2008, 11:01 AM #6
Note that you still need the correct plaster behind and a waterproof layer over the top. The CS will withstand water without falling apart but it still seeps through ... it isn't a barrier so to speak.
-
8th January 2008, 11:19 AM #7
I have been using Durasheet for the current reno in non critical jobs becuase once the sheet gets wet it has tendancy to shatter and crack. Hardies products are much more durable.
-
8th January 2008, 04:34 PM #8Novice
- Join Date
- Jan 2008
- Location
- melbourne
- Posts
- 12
I've replaced the durasheet with the duraliner instead , reading the specs on their website it makes perfect sense and of course , i don't wanna do this job again! Reference the 'waterproof' layer , what would you recommend i use?
-
8th January 2008, 04:40 PM #9
I have used http://www.crommelin.com.au/ which you can get from Bunnings. So far it has performed OK.
Similar Threads
-
Use tile paint or re-tile?
By Loosescrew in forum KITCHENS, BATHROOMS, THEATRES, etcReplies: 5Last Post: 18th December 2007, 12:52 PM -
Manual Tile Cutter or Electric Tile Saw?
By Ronaldo451 in forum TILINGReplies: 10Last Post: 22nd November 2007, 09:56 PM -
Shower floor, Tile over tile; laying to fall
By Ashwood in forum TILINGReplies: 0Last Post: 21st June 2007, 12:38 PM -
Tile Beading.
By makka619 in forum TILINGReplies: 3Last Post: 9th January 2007, 08:24 PM -
Tile Dust
By Babytoolman in forum TILINGReplies: 8Last Post: 12th April 2006, 06:07 PM
Bookmarks