Page 2 of 5 FirstFirst 12345 LastLast
Results 16 to 30 of 71

Thread: old oak table

  1. #16
    Join Date
    Oct 2006
    Location
    adelaide
    Posts
    21

    Default

    the paint stripper is working great thanks..... haha i think the black spots are rain . it was spitting wen i took the picture ........ there is i really dark spot at one end that looks like oil ........

  2. #17
    Join Date
    Feb 2006
    Location
    USA
    Posts
    399

    Default Never a guarantee!

    Try re-scrubbing it with the solvents, if that don't help, then pour on some liquid detergent on the spot, allow it to soak in for ten minutes, and then brush on some very hot water, and then repeat the process..

    If it comes out, then you will have to sand the wood so its ready for finishing.

    Good Luck

    Mac

  3. #18
    Join Date
    May 1999
    Location
    Grovedale (Geelong) Victoria
    Age
    75
    Posts
    9,670

    Default

    Really hard to tell from the pictured as they are a bit small, but it looks to me like you might have a Kauri table top with the typical blackwood or maybe Kauri legs rather than Oak. Could be wrong, but it doesn't look like oak to me.

    Cheers - Neil

  4. #19
    Join Date
    Sep 2007
    Location
    Armadale
    Posts
    887

    Default

    we'll have a better idea when it's clean!
    If you use detergent on it watch out for the dye in it or you can end up with green stains

    Astrid

  5. #20
    Join Date
    Feb 2006
    Location
    USA
    Posts
    399

    Default A better photo would help!

    Neil,

    I agree with you, it don't look like Oak wood to me either, cleaning the wood won't change the woods graining pattern that never changes.

    Cazdids, any luck with the 'oil stain".

  6. #21
    Join Date
    Feb 2006
    Location
    USA
    Posts
    399

    Default Staining?

    Don't be too concerned about the liquid detergent staining your wood, as your going to flush it off with hot water.

    Most detergents use anionic dyes, which actually are micronize pigmemts in water soluble suspensions, and will wash right out.

    I just hope, it removes the stain.

  7. #22
    Join Date
    Sep 2007
    Location
    Armadale
    Posts
    887

    Default

    It dosent really matter at this point what it is.
    could be mountain ash, blackwood, kauri or origon.
    the point is to encourage enthusiasm.
    whatever it is it will look great when finished.

    Astrid

  8. #23
    Join Date
    Oct 2006
    Location
    adelaide
    Posts
    21

    Default

    i thought Kauri had a reallytight notty grain,,,hhhhhhhhmmmm

    ima not sure think i need some help with this will post a better photo

    i was thinking silky oak ( hope it is kauri)

  9. #24
    Join Date
    Sep 2007
    Location
    Armadale
    Posts
    887

    Default

    kauri is pale and tight fairly bland but comes up well with subtle features like bird eyes.

    silky oak is almost like snakeskin.

    Blackwood is like walnut.
    Old mountain ash is often refered to as tasmanian oak because it looks like oak without the radials (little flame like bits running across or diagonal to the main grain) sometimes its hard to tell the difference.

    how' s the prep going?

    Astrid

  10. #25
    Join Date
    Nov 2007
    Location
    inner city sydney
    Age
    55
    Posts
    18

    Default

    My money's on kauri from it's age, form and provenance.

    We get these sorting/packing benches in all the time at the antique auction house I work at...

    My money is on two strips due to it's grain it can join almost invisibly at times.

  11. #26
    Join Date
    Oct 2006
    Location
    adelaide
    Posts
    21

    Default

    yeah think your right its defo 2 pieces ( very good grain match) still not sure about the timber yet though,,, but ima no expert being a pom ,,

    progress has slowed down due too hot weather ...... its outside stripping paint in 40 degrees or inside sat on my ass sipping smoothies in 25 degrees

  12. #27
    Join Date
    Dec 2007
    Location
    india
    Posts
    10

    Default

    Well if you want to restore it try to do th work with care , don't make the original finishing damage....

  13. #28
    Join Date
    Oct 2006
    Location
    adelaide
    Posts
    21

    Default

    ok back to it today before i go back to work

    finish removing paint , done about 3/4 of it

    sand all the legs down

    try to remove oil

    then ima rub the top down

    then i want to keep the rustic look but want to seal it from the weather

    any ideas,,,,,, or any other suggestions for the finish

    Dave

  14. #29
    Join Date
    Sep 2007
    Location
    Armadale
    Posts
    887

    Default

    Happy New year to you.
    Are you going to keep this outside?
    Thats probably OK if its Kauri.
    But mountain ash and blackwood hate water. It will rot and go black if it gets wet on a regular basis. even if you use the most water resistant product on the market. water will get in a scratch.
    I made the mistake of doing my kitchen benches and bathroom unit in ash and itd not wearing well.
    other timbers might be ok, somone else will fill you in when weve identified it.

    cheers
    Astrid

  15. #30
    Join Date
    Oct 2006
    Location
    adelaide
    Posts
    21

    Default

    well its going on my deck under a pergola so no more water than external moisture content . ima thinking just a decking oil
    what do you think ?

Similar Threads

  1. What's The Difference Between A Pool Table & Snooker Table & Billiard Table
    By echnidna in forum NOTHING AT ALL TO DO WITH RENOVATION
    Replies: 47
    Last Post: 26th January 2007, 05:09 PM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •