![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 5 of 5
-
7th November 2007, 08:29 PM #1
Senior Member
- Join Date
- Dec 2006
- Location
- Outer East - Melbourne
- Posts
- 265
Operating instructions for HPM sensor light.
I have a HPM sensor light in the garage. It is a round tennis ball sized sensor 180 degrees hooked up to a flouro light. It has a timer and a lux adjustment. It has an on off switch on the wall.
From what I can find it is a HPM 630/3. There are no operational instructions I can find on the HPM website or anywhere else.
My question is. How do I make it stay on? - and then resume sensor operation?
-
7th November 2007, 08:37 PM #2
Senior Member
- Join Date
- Jun 2007
- Location
- In a House
- Posts
- 256
usually with these units you switch them off at the light sw then on within a few seconds for the unit to stay on all the time for it to go back into sensor mode you usually turn it back off wait about 30 seconds maybe more the turn back on and they go automatically back into sensor mode
-
7th November 2007, 08:39 PM #3
Senior Member
- Join Date
- Jun 2007
- Location
- In a House
- Posts
- 256
this is not a sensor light it is just a sensor correct i think i may have a copy of the instruction sheet downstairs in the shed but it is pissin down raining at the moment if i find it i will scan it and email it to ya!
-
7th November 2007, 08:51 PM #4
Senior Member
- Join Date
- Jun 2007
- Location
- In a House
- Posts
- 256
Instruction book found
Manual Override
There will be times when you wish the light to stay on regardless 0of motion.This is achieved by turning the switch off and on again within 2 seconds the light will ow remain onuntil manually switched 'off' to return the light to sensor or auto mode turn the switch off for longer than 5 seconds and then switch back on..
And that is straight from the installation and opeaing instructions for a HPM 630/3
-
7th November 2007, 10:01 PM #5
Senior Member
- Join Date
- Dec 2006
- Location
- Outer East - Melbourne
- Posts
- 265
Bingo. That is exactly what I was after. Very appreciated, thank you very much.
Similar Threads
-
Who reads instructions?
By Colin Howkins in forum HAVE YOUR SAYReplies: 37Last Post: 25th October 2007, 02:52 PM -
Where can I get a new operating system for my computer for free ?
By JDarvall in forum NOTHING AT ALL TO DO WITH RENOVATIONReplies: 45Last Post: 1st February 2006, 04:51 AM