Operating instructions for HPM sensor light.

[peter_sm]

I have a HPM sensor light in the garage. It is a round tennis ball sized sensor 180 degrees hooked up to a flouro light. It has a timer and a lux adjustment. It has an on off switch on the wall.

From what I can find it is a HPM 630/3. There are no operational instructions I can find on the HPM website or anywhere else.

My question is. How do I make it stay on? - and then resume sensor operation?

[patty]

usually with these units you switch them off at the light sw then on within a few seconds for the unit to stay on all the time for it to go back into sensor mode you usually turn it back off wait about 30 seconds maybe more the turn back on and they go automatically back into sensor mode

[patty]

this is not a sensor light it is just a sensor correct i think i may have a copy of the instruction sheet downstairs in the shed but it is pissin down raining at the moment if i find it i will scan it and email it to ya!

[patty]

Instruction book found
Manual Override
There will be times when you wish the light to stay on regardless 0of motion.This is achieved by turning the switch off and on again within 2 seconds the light will ow remain onuntil manually switched 'off' to return the light to sensor or auto mode turn the switch off for longer than 5 seconds and then switch back on..

And that is straight from the installation and opeaing instructions for a HPM 630/3

[peter_sm]

Bingo. That is exactly what I was after. Very appreciated, thank you very much.