Results 1 to 10 of 10
-
22nd August 2007, 10:11 AM #1Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Icey Looking Decking after being oiled??
Hi Guys,
Im new here so bare with me
Im in Melbourne/Australia and we are just getting over winter, very cold nights and even colder mornings.
We have Merbu decking 54sqm and we oil it every 3mths or when we basically see it getting tacky.
We oiled it at 2.30pm when the sun was out at about 14degrees, although the night after at 7pm when it was very cold we noticed half the decking looking abit white...almost like that icy look.
We have a shade sail on half of the decking and under that it didnt look white but the parts that there was no shade sail it had that white/dry look.
We gave it a secound thin coat last night and had a look this morning, it was 6degrees and some parts had that icy look, but no where near as much as it did last night.
Should i be concerned? Or would it be the moisture/cold wind iceing the decking?
Look forward to your response
-
22nd August 2007, 12:02 PM #2
Welcome.
Now:
1) Are you saying you are oiling in the late afternoon early evening?
2) Are you saying that the weather is just turning from winter to spring? or has spring already arrived?
3) Are you saying that you have left your sail shade up through winter?
4) Are you saying that over night the part you oiled and left out in the cold night air has what appears a glossy look to it while the part under the shade doesnt?
5) Are you saying that you are oiling the deck when its 6 degres?
I hope you read the instructions, is there an instruction on the can that says something like "applied with best results at temps 20 - 30C" then again maybe it wont but Im sure if you read it it may tell you
In all seriousness Chrystal, Welcome to the forumsLast edited by RETIRED; 22nd August 2007 at 12:42 PM. Reason: Because it needed it.
Believe me there IS life beyond marriage!!! Relax breathe and smile learn to laugh again from the heart so it reaches the eyes!!
-
22nd August 2007, 12:15 PM #3
Crystal,
Welcome aboard, I think the dingo has it correct there. Check the side of the can, you will probably find that they warn not to apply if the temp will drop below 10 during the drying time... or something to that effect.
being an oil, wipe any excess off and apply when the conditions are rightI may not have gone where I intended to go, but I think I have ended up where I needed to be.
My Other Toys
-
22nd August 2007, 12:34 PM #4Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Thanks Gra
I did read the can and it didnt say anything about tempreture
The thing that concerns me is that has it ruined the deck permantly, or is it a matter of it wearing off?
Im getting my partner to have a look when he gets home tonight, i have a feeling its only happening when its really cold.
-
22nd August 2007, 01:43 PM #5
As I have several times now welcomed you I shall move on without wasting my breath again.
Now as I see it you can do several things...
1) rub back the whole deck and start again
2) rub back the part that appears "white and icey" and start again
3) keep putting more on it
4) do nothing
There will be results to each of the above your choice which you do and your responsibility for the end result of your choice.
Anyway all the best
Okay mods delete away Im over itLast edited by Stuart; 22nd August 2007 at 01:57 PM. Reason: Because
Believe me there IS life beyond marriage!!! Relax breathe and smile learn to laugh again from the heart so it reaches the eyes!!
-
22nd August 2007, 02:03 PM #6Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Thanks for your help Dingo
-
22nd August 2007, 02:08 PM #7Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Although, im pretty sure it is only because of the cold conditions at night.
Hopefully when i get home it will be all gone seeing as the sun is out and its a beautifull day. I dont think [well i dont hope] its nothing permanant.
If it was permanant it would be all over the decking?
-
22nd August 2007, 02:33 PM #8
Chrystal what type of stuff are you using?... If its got epoxy type resins in it its possibly a "blush" that you can get rid of pretty easily
Actually thats what it sounds like... an after blush that some of this stuff gives off... I know in boat building when the epoxy goes off it can quite often set up a white blush to the timber
Can you try several methods of removing it on an out of the way place?... just a small area try rubbing just water and let it dry... then try a LITTLE terps and let it dry... that sort of thing... but only do a small area thats not going to stand out!
Although thinking about it... have you taken the shade sail down to see if its actually there as well? the shade could be hiding it from your viewBelieve me there IS life beyond marriage!!! Relax breathe and smile learn to laugh again from the heart so it reaches the eyes!!
-
22nd August 2007, 03:00 PM #9Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Although thinking about it... have you taken the shade sail down to see if its actually there as well? the shade could be hiding it from your view[/quote]
It very easy to notice it, especially at night time.
-
23rd August 2007, 11:49 AM #10Novice
- Join Date
- Aug 2007
- Location
- Melbourne
- Posts
- 8
Good news i was right it was just the cold wind. I went home last night and the sun was still out and everything was fine, i looked again around 8ish and it happened again and thats when it was freezing cold
Similar Threads
-
HELP! - Batu Decking with Steel Substructure
By WA_decker in forum DECKINGReplies: 0Last Post: 22nd June 2007, 03:06 PM -
Turning decking timber upsidedown?
By Paul Fitchett in forum DECKINGReplies: 5Last Post: 15th February 2007, 10:12 PM -
Feedback on decking project
By nmilne in forum FLOORING, DECKING, STUMPS, etc.Replies: 6Last Post: 9th January 2006, 10:44 AM
Bookmarks