Overstained maple

[Knurl]

I've used Neil's water-based dye on Maple and find that the color has gone just a touch too dark. Is there some way I can bleach the reddish/brown color to a lighter tone?

[Capt. Zero]

I know no one has replied to this post, I just noticed it tonite. Now I'm a greenhorn, so take this with a grain of salt. I just finished reading a book on finishing (there were 4-5 available and this guy seemed to have the best credentials) and it said you could get a bleach from a hardware store called A-B bleach(two part) that was ideal for this kind of problem. Regular kitchen bleach is not strong enough.
Hope this helps.






"This room is sound proof Nick, no one can hear us here."
"What?"
"I said this room..."
"Huh?"

[Capt. Zero]

Oops. My bad. Just reread the section on bleaching wood. Two part bleaches are for lightening up natural wood color(cherry, walnut, ect.). For your problem the arthur suggests a clorine bleach. However, laundry bleach isn't strong enough and he suggests swimming pool shock treatment. You might try it on a scrap or hidden part of your project first as I haven't tried it yet, so I'm not sure how well it works.
As an aside, he also mentions oxcilic acid for removing water stains, rust stains, ect.





"Young man, where are you from?"
"Nairobi maam, isn't everyone?"

[echnidna]

try a yellow stain over the top of the brown,
it will often lighten brown up a bit.

[son_of_bluegras]

Have you thought of sanding with a fine grit sandpaper? Dyes and stains and all that tends to be a superficial treatment. Lightly sanding will take off just a bit, reducing the amount of dye in the wood which should lighten the appearance.

ron

[Jedo_03]

What I'd try first is wiping it over with a damp\wet cloth...
since the solvent for the dye is water, then water should dilute it...
Give it a wip and see how much stain comes off onto the cloth and how much lighter it is where you wiped...
few wipes over should make a difference
It'll raise the grain so you'll have some light sanding to do - and mebbe sealer...
Jedo

I've used Neil's water-based dye on Maple and find that the color has gone just a touch too dark. Is there some way I can bleach the reddish/brown color to a lighter tone?

[Knurl]

Thank you for thos tips. I might try a) water b) sanding and c) yellow dye in that order until I get the desired affect. I think the water doesn't help after the dye has dried in the grain.

Thanks for all those ideas. I'll let you know how I go.

[martink]

Thank you for thos tips. I might try a) water b) sanding and c) yellow dye in that order until I get the desired affect. I think the water doesn't help after the dye has dried in the grain.

Thanks for all those ideas. I'll let you know how I go.

You may want to try pool chlorine mixed with a little water - this might bleach it lighter or perhaps some IMS rubbed over the surface instead of water i.e. try metho after water and before sanding.

Ciao,

M.