Results 1 to 3 of 3
Thread: Hot Water System
-
15th March 2007, 10:24 AM #1
Member
- Join Date
- Feb 2007
- Location
- WA
- Posts
- 45
Hot Water System
I need to reclad the outside of my reno job. Just using Hardiflex boards. The HWS has to be rmoved before I start but it is about 1.5 mtr high on the wall. Why do they put them up there? Real handy to knock your head on. If it is mains pressure wouldn't it be better of on the ground?
Regards
Greg
-
15th March 2007, 11:20 PM #2
Deceased
- Join Date
- Oct 2003
- Location
- Kentucky NSW near Tamworth, Australia
- Age
- 86
- Posts
- 1,067
If its mains pressure it really wouldn't matter where it was but is a bit unusual.
Originally Posted by gregt
-
16th March 2007, 07:27 AM #3
SENIOR MEMBER
- Join Date
- Jan 2006
- Location
- Melbourne
- Posts
- 722
The instatanious ones often have a little diagnosis diplay on the front. That's the only reaon I could think it might be put at head height ... I have seen a number of them at that height and always wondered why, because it often means they are more visible too.
Mine is much lower ... and works.
Similar Threads
-
Electric hot water system making cold water
By Nolesy in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 7Last Post: 14th December 2006, 08:36 PM -
Hot water goes cold in the pipes: what to do
By silentC in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 31Last Post: 19th July 2006, 10:16 AM -
Hot water system troubleshooting (bosch water wizard 780)
By weezlebub in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 5Last Post: 5th July 2006, 07:41 PM -
simplex hot water system
By pjreno in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 0Last Post: 13th April 2006, 05:31 PM -
Hot water system - Temperature regulations
By notrot in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 19Last Post: 13th September 2005, 05:54 AM
Bookmarks