Results 1 to 15 of 18
Thread: Built in Wardrobes
-
2nd March 2006, 04:49 PM #1Senior Member
- Join Date
- May 2005
- Location
- Melbourne
- Posts
- 149
Built in Wardrobes
We have almost finished renovating an old Victorian place in Hawthorn. Our room and the kids room have large fireplaces with marble mantlepieces and have the gap on both sides of the mantle. He had some free standing old pine wardrobes but now want built ins.
Any hints on the best place to start? I really don't want to go to one of the big wardrobe places as I'm sure they'll rip me...should I go to a local joinery and try there?
We have 12ft ceilings. I want the wardrobes to be floor to ceiling...perhaps not the top cupboard. Maybe some type of plaster bulkhead above as I just hate the look aof having the wardrobe then a gap to the ceiling.
Each wardrobe would be about 120mm wide and we need 4 of them Any idea what we could expectr to pay?
-
2nd March 2006, 06:52 PM #2
Hi vGolfer,
Firstly, I assume you mean 120cm wide (1200mm)?
Depending on the depth, the timber used (especially), and the quality of joinery, etc, I'd suggest that you'd be starting out at around $800 or so each to have them custom made. Quite possibly a bit more, especially if complex shapes need to be made to accommodate out-of-square walls, fireplace, etc (which I would assume a Victorian house to be).
First you need to think about the general design (eg raised panels on the doors, or just louvres), crown or other mouldings, flat or convex doors, number of internal compartments and/or shelves - and their adjustability.
Why not make them yourself?
-
2nd March 2006, 07:08 PM #3Registered
- Join Date
- Aug 2003
- Location
- .
- Posts
- 4,816
Originally Posted by Auld Bassoon
Al :eek:
-
2nd March 2006, 07:28 PM #4Senior Member
- Join Date
- May 2005
- Location
- Melbourne
- Posts
- 149
Originally Posted by Auld Bassoon
I have thought about trying myself, but we've spent so much on the reno I don't want to stuff it up by making dodgy wardrobes.
-
12th March 2006, 12:26 PM #5Novice
- Join Date
- Mar 2006
- Location
- Melbourne
- Posts
- 6
Hi vGolfer,
Depends on how much you want to do yourself. We built 4 large floor to ceiling robes (1.8m to 2.4m wide) into a reno down the Peninsula last week.
We ended up framing and plastering them in ourselves (spending way too long on cornicing and skirting before we learnt how to scribe). But the net result is sensational - they look like they've been there since the house was built.
Total cost for the four robes (without inserts - shelves, drawers etc) was less than $200. If you didn't want to do it yourself - try the local paper for handymen or use the grey army.
The inserts will cost less than $400 for all four - but we're buying flat pack drawers from Armstrongs in Moorrabin and again, doing the rest ourselves (melamine from bunnings).
Armstrongs can do the entire inserts for you (quite cheap, but their timelines were too long for us).
Good luck!
-
12th March 2006, 01:08 PM #6
there are cheaper places than Bunnings to buy melamine-- just have a look in the yellow pages for plywood panel suppliers and ring around
-
5th March 2007, 08:35 PM #7Senior Member
- Join Date
- May 2006
- Location
- Sydney
- Age
- 41
- Posts
- 115
Hey there, see attached, im assuming you have something like this in mind? I have been making enquiries about getting 2 of this style of wardrobe built into my apartment with 280cm ceilings. Apparently having one lot of doors ontop of another makes it more expensive? Anyhow, Im in sydney but am receiving quotes of between $3500-$6500 to do the job - ie. have 2 wardrobes installed (one needs to be 2m wide and one needs to be 1.25m wide so bigger than yours however they are charging me almost the same each as aparently size is not a big factor its the structure they have to lay that is where the work cost is and the doors as the expensize material???) Anyhow, i thought i'd offer my feedback and what i have discovered from getting some over the phone quotes from what seem to be cheaper wardrobe places ... am interested to hear peoples thoughts on if the pricing sounds right though...
A
-
5th March 2007, 08:37 PM #8Senior Member
- Join Date
- May 2006
- Location
- Sydney
- Age
- 41
- Posts
- 115
whoops! just realized this was an 06 thread rather than 07 assuming its already done then
-
5th March 2007, 08:43 PM #9
Ask Felder, he likes to do wardrobes
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
My Other Toys
-
5th March 2007, 08:46 PM #10Senior Member
- Join Date
- May 2006
- Location
- Sydney
- Age
- 41
- Posts
- 115
-
5th March 2007, 08:48 PM #11
sorry, having a go a Felder, he dropped a sheet of melamine on his foot the other week building a relative a wardrobe, was just trying to get a rise out of him....
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
My Other Toys
-
5th March 2007, 09:01 PM #12Senior Member
- Join Date
- May 2006
- Location
- Sydney
- Age
- 41
- Posts
- 115
cupice. if only i had some handy relos!
-
6th March 2007, 08:06 AM #13Senior Member
- Join Date
- May 2005
- Location
- Melbourne
- Posts
- 149
-
6th March 2007, 09:35 AM #14
-
6th March 2007, 09:40 AM #15
Pictures Felder!
You wont get the job if we dont see samples of your workCheers,
Howdya
Proudly supporting research into the therapeutic benefits of the Friday Thread
Similar Threads
-
Old smell in Built in wardrobes
By Peter G in forum KITCHENS, BATHROOMS, THEATRES, etcReplies: 14Last Post: 23rd May 2005, 12:16 PM -
Built in wardrobes
By DavidC in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 7Last Post: 26th January 2005, 10:05 AM -
Built in Wardrobes
By MarkV in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 9Last Post: 6th September 2004, 08:48 PM
Bookmarks