![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 2 of 2
Thread: sparaying kitchen cupboard door
-
16th December 2006, 10:37 AM #1
Member
- Join Date
- Jul 2006
- Location
- syd
- Posts
- 59
sparaying kitchen cupboard door
I just want to match up one panel reasonably well.
The kitchen I think has either 2 pak or vacuum wrapped high gloss white cupboard doors.
I'm remaking the oven surround (new oven) so I just need to make a new panel out of custom wood then spray it.
Keep in mind the oven will generate some heat around the area.
Could I just grab a spray can of high gloss or 2 pak and get a reasonable finish?
any one done this, if so what products did you use?
Do you have to put the polyurethane layer on after? Or is it in the 2 pak..?
Cheers
-
16th December 2006, 07:09 PM #2
Senior Member
- Join Date
- Oct 2006
- Location
- perth
- Posts
- 196
Hi power buff
Just grab the measurements and one of the doors and take it to a laminate supplier, we have GBI (Gibson Benness industies - these guys supply all the cabinet makers with doors) and get them to make it, cost about $50.00, Easier and cheaper.
and it will be exactly the same as the others,
Celeste
Similar Threads
-
Mounting kitchen door hinges
By zendo in forum KITCHENSReplies: 30Last Post: 19th November 2006, 07:55 PM -
Kitchen Cupboard Hinges
By Ironwood in forum KITCHENSReplies: 9Last Post: 26th October 2006, 10:02 PM -
Custome Made Doors For Kitchen Cupboard?
By DPB in forum KITCHENSReplies: 16Last Post: 16th September 2005, 06:16 PM -
Kitchen cupboard finishes?
By AlexS in forum FINISHINGReplies: 2Last Post: 19th October 2003, 10:58 PM