Results 1 to 5 of 5

Thread: Shanes Tip!

  1. #1
    Join Date
    Jul 1999
    Location
    Brisbane, Qld.
    Age
    48
    Posts
    579

    Default Shanes Tip!

    Well lets hope this one can create as much interest as the last tip!! Excellent!

    Ever sprayed something and then come back to find a fine rough surface caused from overspray?

    There are many methods to remove this, but try using the back of a piece of sandpaper. Rub very lightly and this should remove minor overspray problems. This technique is extrelmly useful on two part finishes..
    Have a go!!!

    Cheers
    Shane...

  2. #2
    Join Date
    May 1999
    Location
    Grovedale (Geelong) Victoria
    Age
    75
    Posts
    9,665

    Default

    You could also try U-Beaut Polishes, new, EEE - Ultra Shine. This superfine cut'n' polish wax is fantastic for this sort of stuff and also for getting rid of that feeling that someone threw a hand full of sand onto the finish whilst it was drying.

    Blatant advertising I know. But it's great stuff and worth telling everyone about.

    Cheers
    Neil
    http://www.ubeaut.com.au/eee.htm
    KEEP A LID ON THE GARBAGE... Report spam, scams, and inappropriate posts, PMs and Blogs.
    Use the Report icon at the bottom of all Posts, PM's and Blog entries.


  3. #3
    Join Date
    May 1999
    Location
    Tooradin,Victoria,Australia
    Age
    74
    Posts
    2,515

    Default

    Gooday.

    We use the pink chux abrasive pads for that sort of stuff. Never thought of using EEE.

    ------------------
    Ian () Robertson
    "We do good turns every day"






  4. #4
    Join Date
    Jul 1999
    Location
    Brisbane, Qld.
    Age
    48
    Posts
    579

    Default

    Hi Guys!!

    I might have to try some of that stuff Neil. especially for my gloss work. Although, if the finish was a matt finish wouldn't it gloss the finish up using a polish??

    Also, The chux would scratch the surface??
    I have also used very fine steel wool with a finishing wax and that works, but does leave slight scratch marks.

    I guess it all really depends on the finish itself.

    I just had to use the ole' back of the sandpaper trick, and it worked great, no mess, no fuss, one whole table top done in less than one minute.

    Cheers
    Shane...

  5. #5

    Default

    G'Day Mates,

    For "rubbing out" your finishes.

    If you use the EEE with a little oil, the sheen will be lower, then if it is used it with water. The water, will also give you a clearer look in the finish.

    Also, depending on the coat, over spray can be easily "flowed out" by adding a little retarder to the coating.

    Yooroo,

    Mac

    ------------------


Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •