![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 4 of 4
Thread: Water based enamel
-
21st February 2022, 09:58 PM #1
Water based enamel
Hi all,
Just wondering if anyone has successfully sprayed water based enamel through a gravity feed spray gun? I have a paint spray gun and I've had all sorts of dramas with it. I could be doing something wrong and probably am but I am spraying it white and it was already White so it is really hard to see exactly where I have sprayed and overlap by 50% So I was ending up with a dry type looking spray between my passes, so I tuned the fluid up a bit so I can more see wet coats and have ended up with runs.
I'm hoping if I can spray it trough a gravity feed spray gun with the pressure turned up I'll be able to see more where I have been. I have a gun with a 2.0 needle so hoping I can spray the water based enamel with that.
Be interested in your thoughts on if it can be done or tips on spraying white on white water based enamel paint through a paint sprayer.
Thanks
Geoff
-
22nd February 2022, 09:54 AM #2
I resprayed white outside furniture last week. Used a cheap Trade Tools LVLP gravity fed spray gun with 2mm needle. Paint was water based white exterior gloss (Taubmans from memory from green shed) thinned about 10% with water. Happy with finish for outside furniture.
-
22nd February 2022, 12:26 PM #3
Thanks for the reply.
I'm actually doing semi gloss paint, and it is for bedroom furniture. I find it hard to see the paint going on so I can overlap by 50% on every pass so was thinking maybe if I use the gravity feed with more air pressure I'll sight it better. Not sure it will work but I'm sick of not being able to nail it with the paint sprayer
-
22nd February 2022, 01:57 PM #4
Absolutely impossible.
I used to spray a lot. I have all the gear and an excellent technique.
Eliminating dry spots, maintaining a wet edge, not getting runs, getting it to sit flat... GAH!
Impossible.
Swap to any oil-based you'll be thankful!
Similar Threads
-
The right mix for sealer and enamel (water based) for spraying.
By gocat in forum FINISHINGReplies: 3Last Post: 16th January 2012, 11:17 AM -
Water based or enamel undercoats/primers?
By Goldie in forum FINISHINGReplies: 6Last Post: 8th January 2009, 09:49 AM -
Water based Vs Oil based paint on Weatherboards
By Make it work in forum PAINTINGReplies: 5Last Post: 21st December 2007, 12:40 AM
Bookmarks