Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Metal shafting and tubing
-
17th November 2020, 01:15 PM #1New Member
- Join Date
- Aug 2020
- Location
- Wynyard Tasmania
- Age
- 80
- Posts
- 6
Metal shafting and tubing
I'm just about to commence building my first wood clock, but the design calls for 1/4" brass (or steel) ground shafting and snug-fitting tubing to act as bearings. I'm trying to source these in Australia, with no success so far and fear I may have to order from the USA. Can anyone suggest a supplier? I'd be incredibly grateful!
Alternatively, I have considered using 1/4" hardwood dowel for the shafts, running in small flanged bearings, which I would conceal with wood covers where they are visible from the front. Has anyone tried this or have any comments to offer?
Thanks everyone, and best regards,
Mervyn Mitchell
Wynyard, Tasmania
-
28th November 2020, 11:09 AM #2
Hello Mervyn, I'm a bit slow at answering your query on bearings for the clock. I made a wooden geared clock about 14 years ago, I still have it and it is still running and keeping really good time. I used Lignum vitae ( very hard wood from South America) for all the bushes and shafts and the teeth on the timing wheel. Some of the hardwoods would be ok, even Jarrah or Redgum would wear fairly well. Keep me posted on your progress. John.
-
29th November 2020, 07:43 PM #3
The shaft is no problem as 1/4" Silver Steel is readily available from here but if John says wood can be used, it can be.
Dallas