Thanks: 0
Likes: 4
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: My home made Table saw Jig.
-
4th February 2015, 08:39 PM #1
Senior Member
- Join Date
- Jun 2010
- Location
- Wide Bay Burnett Qld
- Posts
- 189
My home made Table saw Jig.
Here is a Table saw jig I made a few days ago. It is made to hold large and thin strips of timber against the fence. The jig is held down on table saw with a very strong magnet from a hard drive and can be push up against a real thin piece of wood.
Tablesaw Jig for holding timber against the fence 1.jpg (126.2 KB)
Tablesaw Jig for holding timber against the fence 2.jpg (39.7 KB)
Tablesaw Jig for holding timber against the fence 3.jpg (61.3 KB)
Tablesaw Jig Template (Full Size).jpg (34.9 KB)
Cheers Graham.
-
4th February 2015, 09:16 PM #2
GOLD MEMBER
- Join Date
- May 2012
- Location
- Woodstock (Cowra)
- Age
- 75
- Posts
- 3,200
Very interesting, be interested with your feed back after a month or two of use
The person who never made a mistake never made anything
Cheers
Ray
-
4th February 2015, 10:37 PM #3
Senior Member
- Join Date
- Jun 2010
- Location
- Wide Bay Burnett Qld
- Posts
- 189
Hi rwbuild,
It is working so far on boards at 200mm wide and on pieces at 15mm thick that is all I have used on it. But if my table saw sides were wide enough I would like to build something like that to push wide sheet boards against the fence. Also I would need a lot of very strong magnets to do that. I don't have the room to have wide sides on my table saw like a of woodworkers have. I will let you no about the one I built.
Cheers Graham.
Reply With Quote
