Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
8th March 2014, 11:49 AM #1SENIOR MEMBER
- Join Date
- Jan 2004
- Location
- Bellingen
- Posts
- 551
Mystery steel work hardened after welding?
This is a PITA! I though it was some 1020 rod stock.......I did label it a long time ago but the rust around here soon fixed that up.
I got no idea what this stuff is as it must have been a rusty bit I picked up along the way.
I turned up 4 slugs and pre drilled them for a 1/2" tap. Welded them in place and cleaned them up. Was trying to tap them and the bloody things are rock hard! The tap just skated on it. I tried to enlarge it 11.5mm just past the lip...no luck... Any thoughts fellas? It's buried in a piece of 75 by 50 by 3 and welded both sides.... Lovely!
-
8th March 2014, 12:08 PM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 24,746
Did you quench after welding?
Anyway - just heat them up to red again and then let them air cool and you should be OK.
-
8th March 2014, 12:36 PM #3SENIOR MEMBER
- Join Date
- Jan 2004
- Location
- Bellingen
- Posts
- 551
No water quench, they were hot and quick mig welds.. I was thinking about trying that. I might have to duck up to my neighbours place as I do not have an oxy and the part is big enough to act as it's own heat sink.
I sharpened up a masonry bit to bust through to skin an have managed to get one of the 4 tapped. Here is to hoping it's just the first 5mm that hard!
-
8th March 2014, 12:57 PM #4SENIOR MEMBER
- Join Date
- Jun 2012
- Location
- SA
- Posts
- 1,477
-
8th March 2014, 01:21 PM #5SENIOR MEMBER
- Join Date
- Jan 2004
- Location
- Bellingen
- Posts
- 551
I got lucky! Broke a sweat and chipped a tooth on the tap but I eventually got them done!
I'm going to spray the 1020 with pink paint from now on! I'm not in a hurry to do that again.
It could have been a bit of D2 I had floating around from years back. Or I just was unlucky with what was in the scrap pile...? It machined like gummy mild steel...