![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
-
2nd February 2014, 05:40 PM #1
What's the best way to repair this?
My cousin installed the aircon here which I just removed [ Thanx Scott for the muscle] and I'm ashamed to say that I OK'd it.
At the time I did not know any better
The whole of this wall is as shaky as anything I have ever felt but for this particular stud I was going to insert a short section and splint the section down to the noggin or should I remove the noggin use a full length stud and replace the noggin?
The same for all the crippled studs which have no strength at all in the direction of the cut, should I splint the full length and redo all the noggins or just to 150mm above the cut?
Attached Images
-
IMG_0166.jpg (262.0 KB)
-
IMG_0167.jpg (261.6 KB)
-
IMG_0164.jpg (265.3 KB)
-
IMG_0165.jpg (275.7 KB)
Read the full thread at RenovateForum.com...
-