Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
14th December 2013, 02:42 PM #1Senior Member
- Join Date
- Jan 2005
- Location
- Brisbane
- Age
- 52
- Posts
- 350
JPT 310HH Calibration of Thickness Height
Guys I've just returned to using my JPT 310HH after a break of over a year.
I tried to get it the timber down to 11mm but it consistently came out at 11.6-11.7mm
This is with the orange display showing 11.0mm - anyone know the procedure for calibration?
-
14th December 2013, 02:50 PM #2GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 6,891
-
15th December 2013, 01:35 PM #3Senior Member
- Join Date
- Jan 2005
- Location
- Brisbane
- Age
- 52
- Posts
- 350
-
15th December 2013, 09:32 PM #4GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 6,891
Try this as I reckon it would be the same as a Powermatic...POWERMATIC®
item 1791210. That machine has a DRO and I reckon that there is a big chance they may be the same.CHRIS
-
16th December 2013, 12:18 AM #5Senior Member
- Join Date
- Jan 2005
- Location
- Brisbane
- Age
- 52
- Posts
- 350
Thanks, for that. It turns out that they are different. The Powermatic DRO is a proper digital type - why the Jet is a mechanical spinning wheel type.
Note that in the 310HH the read out is displayed as an accessory although I think it comes as standard.
So to adjust - 6mm hex key to remove the adjustment wheel. Remove rubber grommet. 2.5mm hex to remove grub screw then you can freely adjust the dial without it moving the table.
Installation is reverse.