![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 7 of 7
Thread: Jafo :)
-
26th November 2013, 08:57 PM #1
New Member
- Join Date
- Nov 2013
- Location
- Brisbane/Redcliffe
- Posts
- 3
Jafo :)
G'day all, My name's Mick. I'm reasonably new to all this turning stuff and to date haven't done much more than a shaving brush in a bit of off cut timber just to see if I could, and a few fipple blocks for whistles made out of electrical conduit. The blocks were turned down to size from a length of Delrin rod. So as you see I don't have a great deal of experience, and now I find myself in woes with my old lathe, which is the reason why I came here in the first place. I need help sourcing a part for my lathe. Where should I post these sort of questions? Thanks for any help you can provide.
Mick
-
26th November 2013, 09:37 PM #2
GOLD MEMBER
- Join Date
- May 2013
- Location
- Rockhampton QLD
- Age
- 69
- Posts
- 1,570
Welcome to the forum Mick.
-
26th November 2013, 10:16 PM #3
Gidday & welcome aboard Mick, may your journey with us be a pleasant one.
Regards Rumnut.
SimplyWoodwork
Qld. Australia.
-
28th November 2013, 08:27 AM #4
New Member
- Join Date
- Nov 2013
- Location
- Brisbane/Redcliffe
- Posts
- 3
Thanks for the welcome Gents. I've been looking around for a section here to post up my lathe problem, to seek out help, but I'm not sure where I should post it. So I think the small machinery section might be the best area. I'll try there anyway. Thanks again for the welcome.
Mick
-
28th November 2013, 08:37 AM #5
Welcome to the forum
-
28th November 2013, 09:20 AM #6
G'Day & Welcome to a top forum "Mick".
There are quite a few members in and around Brisbane & SE Queensland.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork..
Cheers crowie
PS - It's best to ask the specific question in a number of sub-section to great a wider audience...
GENERAL & SMALL MACHINERY
WOODWORK - GENERAL
HAND TOOLS - POWERED
WOODWORK - GENERAL
WOODTURNING - GENERAL
-
28th November 2013, 03:08 PM #7
New Member
- Join Date
- Nov 2013
- Location
- Brisbane/Redcliffe
- Posts
- 3
Thanks mate. Seems that it doesn't want me to make the post I need to make with photo's. I'm having no end of technical glitches with he forum. Probably user error, but a pain in the behind none the less.
What I need to find out is where to get a replacement rear bearing for Remag WL 800. Any ideas?
Mick