Need some Help/ Advice

[steamjunkprops]

I am currently tuning up my table saw and when trying to true the trunnions parallel to the mitre slots, i am reaching the ends of the slots and i am still about 2mm out.

My question for the metal section is, would anyone with a mill be willing to do a small job for me? Or how hard is it going to be to file these out.



I need 2mm taken off each side of each hole. The slot takes 10mm bolts

[Brobdingnagian]

I am currently tuning up my table saw and when trying to true the trunnions parallel to the mitre slots, i am reaching the ends of the slots and i am still about 2mm out.

My question for the metal section is, would anyone with a mill be willing to do a small job for me? Or how hard is it going to be to file these out.



I need 2mm taken off each side of each hole. The slot takes 10mm bolts

If I understand you right, you just need to elongate the slotted holes right? if so the file would make pretty quick work of that.

[steamjunkprops]

Thats right, ill give a file a go