Thanks: 0
Likes: 16
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 23 of 23
Thread: Round table with wings
-
13th July 2013, 01:09 PM #16
-
13th July 2013, 03:15 PM #17GOLD MEMBER
- Join Date
- Feb 2005
- Location
- Sydney
- Age
- 75
- Posts
- 944
Cane out a treat
Tip work as always. They will be ecstatic
Regards
Greg
-
13th July 2013, 03:21 PM #18
A while back I made a smaller version from a plan in Australian Woodsmith, I was lucky the round over and cove bits in my original (reasonably economy) router bit set matched for the joint. The main thing is getting the special hinges as the centre lines up with the top but is mounted on the bottom.
By the way nice job, but they have already told you that.
RegardsHugh
Enough is enough, more than enough is too much.
-
14th July 2013, 03:30 AM #19... and this too shall pass away ...
- Join Date
- May 2012
- Location
- Brisbane (Chermside)
- Age
- 71
- Posts
- 2,042
Wongo,
You have inspired me to make a smaller, square, card table version. It will be a while coming because I have a bit of work backed up, but I am looking forward to the job.
Thanks!
John
-
14th July 2013, 09:21 AM #20
Nice job Wongo. I really like how the bottom shelf is set into the lower frame, well worth the effort. A beautiful table and very practical.
The time we enjoy wasting is not wasted time.
-
14th July 2013, 12:37 PM #21
Thanks John, go for it and would love to see how yours turns out.
Visit my website at www.myFineWoodWork.com
-
16th July 2013, 02:23 AM #22
Another work in progress that I catch at the end but still a good work in progress to catch.
-
31st August 2013, 07:32 PM #23