![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 6 of 6
-
27th July 2013, 02:21 PM #1
New Member
- Join Date
- Jul 2013
- Location
- Australia
- Posts
- 1
G'day New here- but im puzzled over a project
Hey all - I am currently making a Manual Cylindrical screen printer
the only problem is i can do is the frame etc, but the rollers
i have the trouble of making them or where to start..
Here is a example of the project i am stuck with..thanks in advance
-
27th July 2013, 04:03 PM #2
G'Day & Welcome to a top forum "startarot".
There are a heap of members in and around the country plus the world.
Sorry but can't help much on your question except to say ensure the shaft is lubricated & you have washers either side of the rollers.
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP photos with build notes.
Enjoy the forum.
Enjoy your woodwork.
Cheers crowie
-
28th July 2013, 09:39 AM #3
Welcome aboard, may your journey be a pleasant one.
Regards Rumnut.
SimplyWoodwork
Qld. Australia.
-
30th July 2013, 06:58 PM #4
Welcome to a forum
-
30th July 2013, 11:34 PM #5
I am going to guess that you might want these rollers made out of wood so take a look at the Wood turning sub-section of the forum and post the question there.
WOODTURNING - GENERAL
And welcome to the forum.
-
31st July 2013, 03:25 PM #6
New Member
- Join Date
- Jun 2013
- Location
- australia
- Posts
- 2
the wheels look like skate board wheels (I would buy a cheap skate board from kmart you get wheels bearings etc)
Similar Threads
-
G'day Blokes - Bondwood/Fibreglass Boat Project
By sullyman35 in forum G'day mate - THE WELCOME WAGON -Introduce yourselfReplies: 3Last Post: 28th January 2009, 12:57 PM