Hi,

I'm owner building and am at the stage of fittng architraves. There are a few spots where the 65mm architraves just won't fit. These are the scenarios I have so would appreciate some ideas:

1. Door jamb is right up against wall. These are pretty much all inside built in robes so I figure a piece of quad woud solve this one.
2. Door jamb very close to wall (under 65mm). Should I try and trim the architrave with a table saw to fit?
3. Double windows less than 130mm apart, so an architrave on each won't fit. Should I trim both pieces half the gap and fit them back to back?

Any ideas appreciated.

Cheers,

MJ


Read and reply to the full thread at RenovateForum.com....