![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
Thread: Not enough room for architraves
-
10th June 2012, 03:10 PM #1
Not enough room for architraves
Hi,
I'm owner building and am at the stage of fittng architraves. There are a few spots where the 65mm architraves just won't fit. These are the scenarios I have so would appreciate some ideas:
1. Door jamb is right up against wall. These are pretty much all inside built in robes so I figure a piece of quad woud solve this one.
2. Door jamb very close to wall (under 65mm). Should I try and trim the architrave with a table saw to fit?
3. Double windows less than 130mm apart, so an architrave on each won't fit. Should I trim both pieces half the gap and fit them back to back?
Any ideas appreciated.
Cheers,
MJ
Read and reply to the full thread at RenovateForum.com....
Similar Threads
-
MDF Architraves
By alisonol in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 8Last Post: 5th June 2007, 07:35 PM -
Room-to-Room ducting. . .
By Jedo_03 in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 12Last Post: 1st May 2007, 09:27 PM -
Architraves
By DavidC in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 12Last Post: 12th October 2005, 11:43 AM