Hi,

I am renovating an old timber framed church in Tasmania and want to put up a few non load bearing internal walls to partition off a couple of bedrooms and a bathroom.

The ceiling is sloped and at its highest point is 3.1metres high, at the lowest about 2.4metres.

From everything I have read it is hard to tell if I should be using 90x45 or 90x35 or 75x45 or 75x35.

I was planning on spacing the studs 600 apart, but this can change to 450 if needed to suit the smaller sizes.

If possible I would like to use 75x35 but need to ensure it meets the corect standards.

Any advice would be greatly appreciated.


Read the full thread at RenovateForum.com...