Spindle Repair Video

[.RC.]

ps if any one has a big master surface plate let me know could be some beers in for you

After doing my 36", might want to be a few kegs

[Dave J]

I remember reading on PM about your adventures of scarping that strait edge and it going out of whack within hours. Did you ever get it spot on or just end up leaving it as it wasn't in a climate controlled room?

Dave

[mic-d]

That scraper is shown in Connolly's book but that's the first time I've seen a video of it. It sure does make a long stroke. It is foreign to everything that I've been taught or seen about scraping which is small, refined strokes. In that video its not clear to me what he's doing. Where's the blue? How is that jointer table spotted?

As far as the inserts go: yes please, I'd like one or two of the 25mm inserts.

Greg

Don't ask me, I'm just a dumb woodworker I'd also like a bottle of dye please Greg, I'm a bit over blue.

Interest in the insert noted.

[eskimo]

Hi GQ

if theres any bottles left I could use some
just acquired a 4ft straight edge from an old engineering buddy he had it lying around in a pile of junk got it for free
needs a bit of work to bring it back to its former glory
now all i need is to learn how to scrape

cheers
Harty

these things are very common ...only Dave cant find one

[.RC.]

The other point about blue over red is if you go take a leak and get some on your stalk the blue colour will not raise any suspicions with your other half... (unless you are chasing smurfette)

[eskimo]

The other point about blue over red is if you go take a leak and get some on your stalk the blue colour will not raise any suspicions with your other half... (unless you are chasing smurfette)

hahahahaha......you need to keep your mind above your navel RC....