Results 1 to 5 of 5
-
12th May 2011, 03:45 PM #1Marty333 Guest
Pergola - sizes and timber to use
Hi All, firstly i hope ive got this in the right forum!
In a couple of months i plan to start using some of my long service leave, after 10 years i think i need a break. Of course there isnt much point sitting on the couch for a couple of months so ive decided to make an outdoor room / pergola!
I want a 10m x 5m pergola attached to the existing house i then want to insulate the roof / ceiling and install a nice deck around it. Ive been doing a lot of research and thinking into how im going to do this. In its most basic form im thinking that i will install 190mm x 45mm beams around the entire top (1 side attached to the existing house) then use 145mm x 45mm rafters. The posts will be 90 x90 attached to the ground with post shoes. A couple of questions / recommendations i had around this
- will 190mm x 45mm be of adequate size for the beams? or will the weight off the room require something bigger, can i get away with a smaller size?
- how far should i space the rafters apart, 900 mm max?
- I live in Adelaide and we don't get a lot of rain, can i get away with putting the post directly into the ground without post shoes?
- How far can i space the posts at the front of the pergola (10m frontage) i was thinking 4 posts over 10 metres? (including the corners)
Any other suggestions or advice would be greatly accepted. thanks!
Marten
-
13th May 2011, 02:21 AM #2
Buy that book an you ll never look back Buy The Australian Decks & Pergolas Manual - edition 5 - BOOK-DPM by thats a like where to buy it from but you can get it at bunnings its an absoulte must have. I ve got the whole series I ve pointe out the decks an pergolas book an good luck with it. As for timber on ground ? silly question there isnt very many places you can do that go with the saddles do it once do it right
-
13th May 2011, 09:54 AM #3
Better check local regulations for footing size too.
-
14th May 2011, 09:33 PM #4Novice
- Join Date
- Apr 2011
- Location
- Coldstream, Australia
- Posts
- 2
couldn't agree more gotta go by regulations, larger rafter spacings means larger rafters and larger battens 450 is standard you may find the 140x45 a bit small over 5m especially if your going to insulate and line the roof all adds more weight! I like to go bigger just to be sure it lasts forever not just 10 years!
good luck sounds like a decent project!!
-
14th May 2011, 09:58 PM #5New Member
- Join Date
- May 2011
- Location
- Sunshine Coast, QLD
- Posts
- 4
What are you putting on the roof? What pitch?
Bookmarks