![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
Thread: Fitting new door handles
-
17th January 2010, 10:00 PM #1
Fitting new door handles
Hi all,
Just wondering what the best method would be to bore out a existing hole on a door to fit new handles? The hole saw and bore drill will not work as there is no pilot hole for the drill to fit into so it will most likely just skid over the place.
The old door handles used a much smaller hole and the latch hole is a few mm smaller too. The latch hole I was going to just use a file as its only a few mm.
Any ideas? Thanks
Read and reply to the full thread at RenovateForum.com....
Similar Threads
-
fitting an old door
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 28th March 2009, 10:40 PM -
fitting Door Jam Questions
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 21st February 2009, 11:30 AM -
Fitting a Door
By DavidC in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 1Last Post: 14th October 2005, 08:42 PM -
door handles
By reybec in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 6Last Post: 29th June 2005, 06:44 PM