![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
Thread: Cooktop Hole Too Big
-
29th October 2009, 12:30 PM #1
Cooktop Hole Too Big
Planning to replace our aging gas cooktop but the existing hole is 950mm wide.
There are only a handful of models on the market that will fit.
One option might be to fill the gap on either (or one) side with some sort of infill, as this would then give many more options in terms of cooktops that will fit...ie pretty much any "900mm" model on the market.
This might actually be useful as it would give a place to put hot things on. Current benchtops are laminate and don't really want to replace them at this stage.
If I went for a stainless fill-in bit on the side how would that actually work? Would it just sit on top of the existing bench? I thought if that were the case the 'surface' that the benchtop sits on would then be uneven...but if the stainless was thin enough, would that matter?
Or would you router the surface so the stainless sits flush (or below) the existing benchtop.
Another option would be to get a frame to go right around the hole (rather like a picture frame)...presume this would be easier to install.
Who would I get to make this sort of thing?
Read the full thread at RenovateForum.com...
Similar Threads
-
Want to drill a 3rd hole in a 2-hole Vanity Basin...
By Batpig in forum BATHROOM & TOILETReplies: 10Last Post: 1st November 2007, 11:14 PM -
Bigger hole for a bigger cooktop
By StartAgain in forum KITCHENS, BATHROOMS, THEATRES, etcReplies: 5Last Post: 31st October 2007, 03:24 PM -
From 600 Cooktop to 900 Upright
By mirz in forum KITCHENSReplies: 8Last Post: 12th May 2007, 09:26 AM -
Repainting cooktop
By al2 in forum KITCHENSReplies: 10Last Post: 13th June 2004, 01:33 PM