



Results 1 to 15 of 18
Thread: Painting Straight Lines
-
14th September 2006, 09:41 AM #1
Painting Straight Lines
Hey All,
I am painting my living room, and I would like to paint the walls a different colour to the ceiling. The ceiling being a lighter colour to the walls. I have square set edging.
I have tried taping before and this can lift the paint. I was wondering what people can recommend to get a nice straight line between the walls and ceiling colours??
Thanks
-
14th September 2006, 09:47 AM #2
Practice.
(but you can also buy tape with varying degrees of stick for exactly that purpose, go to a trade supplier and ask. I think it's light blue, almost no stick at all really)
Cheers,
P
-
14th September 2006, 09:59 AM #3
By hand is the best way. Had a mate do most of the painting at my place and he had a roll of that blue tape. Once or twice it bled through. Steady hand and a good cutting in brush is the way to go.
I once helped paint a private hospital. They wanted two tone colours with one colour from skirting to chair rail height and a different colour from there to the cornice. There was no chair rail, so we pinged a chalk line all the way around and cut in by eye. You get very good at it after the first kilometre"I don't practice what I preach because I'm not the kind of person I'm preaching to."
-
14th September 2006, 10:43 AM #4
Invest in a good brush and most of your prolems are solved.
-
14th September 2006, 11:10 AM #5
Has anyone used a metal straight edge?
-
14th September 2006, 11:13 AM #6
Great for the first line but a pain to keep cleaning it. The steady hand with the good quality brush is the way to go and or course, use good paint.
-
14th September 2006, 11:18 AM #7
The problem with paint is that it is based on a liquid which is subject to capiliary action.
If there was an easier/faster/better way, believe me the house painters would be on to it.
If you really want to try the handyman approach, get one of those pads with the rollers on the edge."I don't practice what I preach because I'm not the kind of person I'm preaching to."
-
14th September 2006, 11:22 AM #8
Again great till the rollers get paint on them, I tried one and threw it away in disgust. Must be that I'm getting better at it after practice but it no longer seems an issue since I swapped to a good brush, much faster now and so easy, use long steady movements rather than short strokes.
-
14th September 2006, 11:28 AM #9
Thanks for the help. I think I am just going to have to give it a go with a good brush and a steady hand. Any particular size brush? And if it doesn't work out I'll just have to use 1 colour.
-
14th September 2006, 03:37 PM #10
Lines can be a pain! With our extention and additional reno's - 4 bedrooms, a long passage way and a bathroom, I used teh light blue painters tape. It comes with varying sticking times - eg 3 days, 14 days, up to 60 days. Has a light but firm adhesive action and presses down easily - and can be lifted and stuck down again if needed - and does not allow the capilliary flow under the edge. Plus it pulls off very cleanly when the paint is dry.
I used the 60 day stuff because I didn't know how long I would need to leave it down and had no problems. Masked around windows, arch's and skirts, door frames, everything, then painted. And it was BLISS!
Maybe if you only have a small area to do, then by hand might be the go, but for anything bigger than 1 room I woudl strongly suggest getting stuck into the tape (so to speak). Worked well in corners too, where we had walls of 2 different colours joining in the corners. And just brilliant for masking the cornices off from the lining board ceilings.
Happy painting, however you do it....
Jeff
-
14th September 2006, 03:40 PM #11
forgot to mention - a good quality cutting-in brush is a must, but make sure it has a reasonably firm 'action'. We tried a couple but one was just too soft in the bristles to control properly and the bristles were too long. Wound up using a brush that was about2 inches wide with a bristle length of about 3 inches. These were good synthetic bristel numbers - pale blue bristles and not too expensive, just really good.
Jeff
-
14th September 2006, 03:47 PM #12does not allow the capilliary flow under the edge
The other problem with using tape is that you can lift the new paint when you pull it off, leaving behind a tear. Needs to be removed while the paint is still wet, or you need to run a knife over it (depends on the situation).
I use a 3" oval brush (Rota-Cota I think)."I don't practice what I preach because I'm not the kind of person I'm preaching to."
-
14th September 2006, 10:16 PM #13
Scotch 3M put out a product called "safe release painters masking tape" its a low adhesion 7 day removal tape and it works a treat. Product code is #2070. Availabe at most good hardware shops. As we are reno'ing our house my partner wanted lots of feature walls. *sigh* We used this tape for the feature walls to get straight lines and I put it on top of 2-3 day old paint and it didn't lift a single bit of the new paint off when removed. It also is very easy to unstick and stick again to get true straight lines. This tape when removed leaves a very nice sharp line. Like everyone here says get a real good quality cutting brush. I use the Rokset 38mm synthetic bristle (blue bristles) cutting brush with the longer handle (from bunnings) for my cutting and they are fantastic, worth every cent I paid for it. With any cutting on the odd occasion no matter how good the tape is you may get a minute amount of bleed through, I use the art brushes (purchased from Spotlight hobby section) to just touch up the odd tiny bit of bleed through that we got and it was a minute amount. Any straight line is only as good as how straight you put the tape on.
http://products3.3m.com/catalog/au/en005/home/home_care/
node_GSHLZTYS7Xgs/root_D58K9TX3VWgv/vroot_WSMGLWV03Mge/bgel_8BM
3XX068Jbl/gvel_X3F182CPR7gl/theme_au_homecare_3_0/command_AbcPageHandler/
output_html
-
14th September 2006, 11:39 PM #14
Good brush
Monarch cutting in brush , it is cut at about 30 deg across the face around $30 + for a 2" 50 mm and is fibres not brissles, can be found at bunnies.
RgdsAshore
The trouble with life is there's no background music.
-
15th September 2006, 09:39 AM #15it didn't lift a single bit of the new paint off when removed
Similar problem, I had to remove a powerpoint after the painting had been done. The painter had lapped the paint over the edge of the powerpoint and so when I pulled it off the wall, some of the paint came with it. Strong stuff, paint. Should've run a knife around it first."I don't practice what I preach because I'm not the kind of person I'm preaching to."
Similar Threads
-
Wood straight, come off it!
By Tiger in forum LANDSCAPING, GARDENING, OUTDOORSReplies: 3Last Post: 10th September 2005, 01:35 AM
Bookmarks