Cutting Corro iron

Printable View

Show 40 post(s) from this thread on one page

9th April 2018, 02:26 PM
BallaratBill

Quote:

Originally Posted by 62woollybugger

To cut it along the corro, score it the full length with a stanley knife, then grab one edge & give the sheet a whip crack. It'll just break along the score line, I wouldn't believe it until I saw it done.

Knowing my awesome luck, I'd end up scalping myself. Not that there's much hair left to worry about [emoji23]
Any vids about showing this method?

Sent from my SM-N910G using Tapatalk
24th February 2021, 06:49 AM
GaryJ

Reviving an old thread but does anyone know if the snip and tear method across the sheet also works on Trimdek profile?

Show 40 post(s) from this thread on one page

All times are GMT +11. The time now is 03:59 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.