Yvan, I wish we in jail down here could go to auctions and markets where we could buy things we don't need. See you next week.
Printable View
Yvan, I wish we in jail down here could go to auctions and markets where we could buy things we don't need. See you next week.
PagieQuote:
Originally Posted by Pagie
Seeing your currach reminded me of a time long ago when I accompanied a bloke to pick up a coracle, the Welsh boat that is either round or nearly round and paddled with a single oar worked in a figure of eight pattern.
Regards
Paul
So what are we going to decide to put our knowledge to this week?
Sharpening, carving, clamping, hardening steel. Something else?
:coffee::coffee::coffee::coffee::drink2:
How about virtual shed tours ?
Cheers Matt.
:oo:Quote:
Originally Posted by Simplicity
Luckily I only use a desktop. No wheels, although arguably I could use one with training wheels, but not for mobility. :wink:
Regards
Paul
Hi All,
It's nearly Friday again (YESSS and YAY!)
Rather than a specific topic this week, let's do a "What's on your bench" show and tell?
I really like Matt's idea of some workshop tours, so perhaps we can arrange someone for next week to show us around. I know I really enjoyed seeing Doug's workshop and surrounds during his bench reveal.
Anyway, as usual, open to any and all who have a spare 40 minutes (or just prefer to chat than work).
Time: 12:00 - 12:40 ADST
Join Zoom Meeting
Launch Meeting - Zoom
Meeting ID: 789 4886 9892
Passcode: 123
See ya tomorrow [emoji106]
Cheers Matt.
Good too see everyone,good catch up.
Cheers Matt.
These are the calipers that I was talking about. They are not super high quality, its mild steel but I think they are accurate. They are also 10". I think they are better than what you can buy on ebay.
But just as I was to post his. I did a search on McJing. They have 12" calipers for 18 bux each. So that might be an option.
Thanks all again for the chat, i pulled the pin on a new Harvey Ambassador c200-30 after we finished up... hope to see it before xmas :)
I might put the fully automated router table back a little bit though.
Nice to hear and see what we are all working on
Lance, what kept coming to mind is pattern follow tooling and i found this diy version that could be of interest A Poor Man's Lathe Duplicator Rig
Something is wrong with the connection. I was the only one there but I see several other regulars are browsing. Same thing for you?
Regards
Paul
Hmmmm. Time frame? Daylight saving?
S*?t!
Regards
Paul
Paul, all seemed normal for the zoom meeting though Pagie had a low bandwidth connection againQuote:
Originally Posted by Bushmiller
I wondered what happened to you Paul :(
Thanks Doug, Matt, et. al. for your advice about pull duplication.
With the pattern and measurements, and playing join-the-dots, I got really close.
Original is Tasmanian Oak with brass insert, the copy is blackwood with a Huon Pine insert. These practice pulls are to good to throw away. I'll have to build something that can use them!
https://uploads.tapatalk-cdn.com/202...a855b05bd4.jpg
LolQuote:
Originally Posted by Bushmiller
No comment, from the Boy in virus town.
Cheers Matt.