Fitting new door handles

Printable View

17th January 2010, 10:00 PM
Reno RSS Feed

Fitting new door handles

Hi all,

Just wondering what the best method would be to bore out a existing hole on a door to fit new handles? The hole saw and bore drill will not work as there is no pilot hole for the drill to fit into so it will most likely just skid over the place.

The old door handles used a much smaller hole and the latch hole is a few mm smaller too. The latch hole I was going to just use a file as its only a few mm.

Any ideas? Thanks

Read and reply to the full thread at RenovateForum.com....

All times are GMT +11. The time now is 10:58 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.