AlexS
8th December 2008, 02:26 PM
I don't usually do repairs or restorations, but just did a little job this morning, & will post pics later. It was a nice little piece, and all that had to be done was to repair severe water damage on the top. Removed the shellac with metho, sanded, gave a light wb stain to match the rest, and re-finished. Cleaned up the rest of the job with Ubeaut polish reviver.
I have two questions:
1. The edge of the top & bottom seemed to be finished with heavily pigmented shellac. Was this normal in the mid 1940s, & if so, why was it done?
2. The maker has signed & dated the ply back in soft pencil. This has been wiped at some time, probably when the water was spilled, and the signature is smeared so it's not quite readable. I'd like to be able to read it, and if possible, restore it so it stays readable. I'm thinking of misting with water then lightly sanding, unless anyone has another suggestion. I'm hoping the water will raise the fibres around the writing, but not on the writing itself.
Pics now posted, minus drawers.
I have two questions:
1. The edge of the top & bottom seemed to be finished with heavily pigmented shellac. Was this normal in the mid 1940s, & if so, why was it done?
2. The maker has signed & dated the ply back in soft pencil. This has been wiped at some time, probably when the water was spilled, and the signature is smeared so it's not quite readable. I'd like to be able to read it, and if possible, restore it so it stays readable. I'm thinking of misting with water then lightly sanding, unless anyone has another suggestion. I'm hoping the water will raise the fibres around the writing, but not on the writing itself.
Pics now posted, minus drawers.