shipsong
13th May 2008, 10:53 AM
I tried to post this before but think I failed - so sorry if it is a duplicate.
I am wanting to replace a treated pine deck around my pool. Our yard slopes steeply and has a rock cliff halfway down. The pool is built on the lower level - ie an above ground concrete pool set on piers so that the deck is level with our upper yard. The existing deck has treated pine posts (set in the ground - up to 3m high), bearers and joists with the joists also sitting on the conscrete pool edge. It is about 10 years old and the boards are splitting and lifting.
Can I keet the old posts, bearers and joists and just replace the deck or should I replace the lot?
Are the posts OK in the ground or should they be sitting in stirrups?
I would like to lower the joists so they are attached to the side of the pool (rather than on top) and have a row of pavers around the pool edge and the deck flush with them. How should I attach the joists to the side of the concrete pool. Joist hangers dyna bolted into the concrete (a lot of drilling and dyna bolting)? Or can I dyna bolt angle iron or something else for them to sit on (if so what spacing/sizing of bolts)?
Final question. I am wanting to use a composit edecking board rather than wood I have to stain. I'd prefe a dark hardwood look but haven't seen one I like (Modwood colours not great - jarrah looks too red). any suggestions?
Thanks,
Peter
I am wanting to replace a treated pine deck around my pool. Our yard slopes steeply and has a rock cliff halfway down. The pool is built on the lower level - ie an above ground concrete pool set on piers so that the deck is level with our upper yard. The existing deck has treated pine posts (set in the ground - up to 3m high), bearers and joists with the joists also sitting on the conscrete pool edge. It is about 10 years old and the boards are splitting and lifting.
Can I keet the old posts, bearers and joists and just replace the deck or should I replace the lot?
Are the posts OK in the ground or should they be sitting in stirrups?
I would like to lower the joists so they are attached to the side of the pool (rather than on top) and have a row of pavers around the pool edge and the deck flush with them. How should I attach the joists to the side of the concrete pool. Joist hangers dyna bolted into the concrete (a lot of drilling and dyna bolting)? Or can I dyna bolt angle iron or something else for them to sit on (if so what spacing/sizing of bolts)?
Final question. I am wanting to use a composit edecking board rather than wood I have to stain. I'd prefe a dark hardwood look but haven't seen one I like (Modwood colours not great - jarrah looks too red). any suggestions?
Thanks,
Peter