PDA

View Full Version : Best router bit for Hettich Sliding door system















JontyG
21st February 2008, 11:04 AM
Hi,

I have a Hettich Slideline55 slidiing door track to install.

I have been trying to work out which router bit (size and profile) would be the best to use for routing out the groove for the track. Attached is a pic of the actual track, and an installation guide from Hettich. I've tried to contact Hettich RE a recommendation for the most suitable router bit to use, to no avail.

Any help will be greatly appreciated.

Thanks,
Jonty

journeyman Mick
21st February 2008, 09:52 PM
Jonty,
you need a slot that's 7.5mm wide and 5.5mm deep. Ideally you'd use a 7.5mm wide bit set for that depth but in reality they're probably not readily available and you wouldn't want to buy one just for the one job anyway. Use a smaller bit (eg 6mm or 6.4mm) and make a second pass. Or if you had a saw with a dado set and you could get down that narrow you could use it.

Mick

JontyG
22nd February 2008, 09:07 AM
Jonty,
Use a smaller bit (eg 6mm or 6.4mm) and make a second pass.
Mick

Thanks Mick, didn't think of that :doh: