Grinder-hole???????????????

[Learner]

food grinder to be installed under kitchen sink. But sink is old design smaller hole.

How to enlarge hole in stainless steel sink???????????????:?

Insinkerator designed for larger mouth sink

http://www.reece.com.au/bathrooms/products/2035153

http://www.bournebathrooms.com.au/bathroom-kitchen/product_info.php?name=Insinkerator%20Model%2045&products_id=99


http://articles.homeone.com.au/insinkerator.php

Help greatly appreciated.

Regards and thanks :U:D:U

[DJ’s Timber]

You'll need to pull the sink out and get the hole re-punched, check at your local plumbing supply.

[Learner]

You'll need to pull the sink out and get the hole re-punched, check at your local plumbing supply.

million thanks.:D

[journeyman Mick]

I don't know that most/any supplier will have a waste disposal sized hole punch. Generally they only punch in the holes for tapware as the manufacturer pre-punches the sinks for the wastes. You'll also need to recess the area around the waste a few mm to stop water ponding around the raised lip of the waste unit. A sheetmetal fabricator that does a lot of stainless fabrication for commercial kitchens may have the required gear, but I wouldn't want to bet on it. I'd make a few phone calls and if that didn't find anyone I'd be measuring up the existing sink and forking out a couple of hundred for a new one.

Mick

[China]

Aompany called Woodroff sheet meatl can do the job the also repolish sinks, They are SA but are a division of Hills industries so they may have outlets in VIC