PDA

View Full Version : Advice required on servicing old A12 Sunbeam Mixmaster















Jim Duncan
6th May 2006, 09:51 AM
Hi,

I would greatly appreciate someone advising me how to remove the front cover of my wife's vintage A12 Sunbeam Mixmaster (so I can pack some new grease around the gears).

Thanks for your reply.

Daddles
6th May 2006, 01:27 PM
Ahh, a bloke's first post. So it's appropriate that the advice given be appropriate. Use a hammer mate :D

Richard

welcome to the asylumn. Sorry, I don't know the beastie in question so can't really help:rolleyes:

Ashore
6th May 2006, 03:26 PM
Hi Jim and welcome to the forum
Don't know if its an A12 but if its like this one there should be a round gold coloured disk with an "S" on each end . Use a small flat screwdriver to gently pop these off and you should find a locking screw under each one ,
Where you go from there is up to you , sorry but I don't have the time to strip this one to see how it works,

Rgds

JDarvall
6th May 2006, 03:29 PM
mate, a while back, I fixed mine.....I don't know if it was an A12. But it was definetly a sunbeam mixmaster.

Its here......
http://www.woodworkforums.ubeaut.com.au/showthread.php?t=21557&highlight=sunbeam+mixmaster
I had a capacitor problem though

I had some trouble if I recall as well getting into it. I don't know exactly which end it was ???:o sorry I've got a crap memory.......I managed to get into it finally by removing a metalic disk at one end.....it was pushed in....had to pick it out with a screwdriver I think.....behind the disk is a screw....have to get to that screw for it to come apart. Hard to get the disk out without damaging it.

hope I've given you something amongst all that raving....goodluck. ;)

JDarvall
6th May 2006, 03:30 PM
Jesus Ashore !.....you beat me to it. hate that. :D

Jim Duncan
7th May 2006, 12:16 AM
Richard,

Thanks for the welcome in not the advice.

Jim

Jim Duncan
7th May 2006, 12:24 AM
Ashore,

Thanks, that is exactly what I needed to know, The A12 has the same end caps. The model number is stamped on the mixer body where it connects to the stand.

Thanks again

Jim

Jim Duncan
7th May 2006, 12:32 AM
Hi Apricotripper,

Thanks for the info. Ashore's earlier answer also supports the endcaps explanation. I owe you special thanks because my search engine found your original request for help on the sunbeam capacitor problem, and lead me to this interesting, useful and slightly strange "mens business" site.

Thanks again.

Jim

JDarvall
7th May 2006, 03:41 PM
:D

Pleasure Jim. :)

scooter
7th May 2006, 09:35 PM
...and lead me to this interesting, useful and slightly strange "mens business" site...

You don't know the half of it... ;) :rolleyes: :D

JimL
25th July 2008, 05:11 PM
Hi All, This sounds all pretty weird, I have just joined this Forum to find out exactly how to do the repair to the mixmaster.

I googled mixmaster repair and got the original appricotripper thread.

And my name is Jim as well!

I think I will have a rum..... then later try to get the end cap off the mixmaster to get at the ..........thingys and stuff.....

Cheers,
Jim. :q

More rum......

JDarvall
25th July 2008, 05:24 PM
more rum......

.....:d...