PDA

View Full Version : Attaching trim without nails















Tiger
31st January 2006, 11:35 AM
Dear all,

A piece of trim that covered the edge of a kitchen cabinet has fallen down. It was attached by a few blobs of a yellow/brown glue. I would like to reattach the strip but which glue should I use and how to secure it to the wall/cabinet so the glue can take. There are no nail holes in sight, so do you just stand there and apply pressure for a few hours :confused: .

echnidna
31st January 2006, 12:53 PM
Scrape all the old glue off before you apply new glue.
Pva should work
(or contact adhesive or liquid nails though they can be a bit messy to use)
Hold the trim on with masking tape till the glue sets

Wood Borer
31st January 2006, 12:58 PM
Edge clamps if you have any or use G clamps and three pieces of timber as follows:

A piece on clamped on both sides with the third piece pressing against the strip but held with clamps between the side pieces and the piece holding the strip.

Another way is masking tape or fast setting glue such as superglue.

If the original strip was ironed on, then perhaps running over it with an iron might fix it with a bit of extra hot melt glue.

Tiger
2nd February 2006, 10:56 AM
Thanks, guys I'll try the masking tape.

markharrison
2nd February 2006, 07:16 PM
Actually, you'll find clear packing tape to work better. You can put more pressure on it.