Hi All

[JoeW1964]

Finally after enough procrastination I have got myself a wood lathe. Picked up an old Toolmac N3570. Has not had much use so good to get started on. Just looking at getting some Vicmarc stuff, chuck, etc. The lathe I bought does not have a manual, would anyone know where I could get one.

[old1955]

Welcome to the forum Joe.

Ross

[crowie]

G'Day & Welcome to a top forum "Joe".....
There are quite a good few members around Hunter region and cross NSW plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork......
Cheers crowie

PS - On your lathe question, may I suggest you start a new thread in the woodturning section as you'll get a bigger audience and thus more potential answers....

[verawood]

Welcome Joe

[KeithP]

Welcome to the forum.

Regards
Keith

[bruceward51]

Try posting in the woodturning forum and include the model of the lathe in the title. Many of the long-term members only follow the forums of interest to them and others scan the new posts and read the titles that grab their attention.
Have you tried searching for the manual?
Bruce

[Old Croc]

Hi Joe, welcome mate.
Rgds,
Crocy.

[JJF]

Welcome to the forum

[Treecycle]

Welcome JoeW1964 and I hope you enjoy your turning adventure. When looking for info on the Toolmac N3570 it comes up with a metal lathe (https://metalworkforums.com/f223/t149972-lathe-n3570) or a Thicknesser, so not having any luck for you.