PDA

View Full Version : casting with West System 105 Epoxy Resin and 205 Hardener















barrysumpter
18th March 2020, 03:03 PM
I've already used liquid silicon to make a mold for the item circled.

Wondering if anyone might have an issue with me casting with West System 105 Epoxy Resin and 205 Hardener.

I've measured the volume with water displacement of 100ml. The other pic is the calculation for 1:5 ratio. I haven't found anything about the resin expansion.

470105470106

Cal
19th March 2020, 05:38 PM
What is the item that you are casting? It looks like a clamp for something?

barrysumpter
19th March 2020, 05:46 PM
470154
It's the first bit that bolts into the clamp.
It's the weakest point.

Cal
19th March 2020, 06:16 PM
I would add a bit of fibreglass into the mix to add strength to it. It may hold without it but I would add the fibreglass for sure.
West systems isn’t a casting resin as such, it may get too hot as it cures even though the volume is small. Another reason to add the fibreglass.

Tonyz
19th March 2020, 08:45 PM
tell more about your liquid silicone please....was talking about this last night

barrysumpter
30th March 2020, 08:17 PM
Liquid silicone Rubber, mould making heat resistant 2 part silicone 1KG Colour | eBay (https://www.ebay.com.au/itm/Liquid-silicone-Rubber-mould-making-heat-resistant-2-part-silicone-1KG-Colour/184060589444?ssPageName=STRK%3AMEBIDX%3AIT&var=691751878995&_trksid=p2057872.m2749.l2649)