PDA

View Full Version : New power point fed from AirCon Isolator Switch?



woodPixel
1st August 2019, 11:47 PM
Hi all,

I've just moved into a sweet little 2Br unit.

Need some wisdom, from those wise in these matters! I thought to ask the forum before I go to the expense of talking with a sparky.

The balcony outside has no power point :( but it does have a monster aircon.

Can I get (as in, Is It Allowed under Ze Rules) to put a power point (an outdoors style water proof) fed from this isolation switch?

The power board says the AirCon has an RCBO 20A going to it.

Clearly the juice for the new point/s would be fed from the input side of things.... or is it best, if one can, to run it after the isolator switch?

I am in Canberra ACT if it is of any consequence.

It is simply so I can plug in my small electric hibachi, run the scrollsaw and put up my xmas lights :) blink blink! :)

TIA dudes!

458947 458945

poundy
2nd August 2019, 08:19 AM
unlikely. I am not familiar with rules and regs, but this would be a specific purpose connection (the AirCon) on the fuseboard, and a GPO would need to be on a GPO circuit. Is there a GPO on the inside wall along the balcony? Often that's the simplest answer, punch thru from the inside where the power exists.....

BobL
2nd August 2019, 10:38 AM
My understanding of the regs is large draw devices like large AC units must be on their own breaker with nothing else attached.

When our last installed AC unit was hooked up to one of the existing 10A house circuits I queried this with the supplier of the AC and he agreed and said that the sparky he had sent around to do the install had done this once too often and was the last time he would use him. Another sparky came around within 24 hours and installed another breaker just for that AC.

In terms of electrical safety, if a cross over switch was fitted (either the AC or the other power point was ACTIVE) there should be no safety issues, whether that meets code is another issue.

PJM16
2nd August 2019, 06:41 PM
Definite no go. High power items need to be on their own circuit. As mentioned above, if there's an internal powerpoint on the same wall, that can probably used to provide power.