Stainless Steel Sheet

[DPB]

I'm renovating my kitchen as noted in previous post re kitchen cupboards.

I now require a source for stainless steel sheets. Don't need a lot, just enough to fit flat on the wall behind canopy hood fan (905 x 800mm). Need it cut to size.

Where in Melbourne area?

[Auspiciousdna]

I’d ring some Sheetmetal shops around your area that work with SS and ask for a quote for the sheet size you’re after. 16 gauge should do the trick.<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /><o:p></o:p>

[DPB]

Ta! will give it a try.

[Termite]

Ring around the kitchen cupboard mobs, there is a brushed finish ss made just for this very job and for splashbacks. Apparently does not show fingerprints etc. as much.

[Wildman]

I got my splashbacks made by Auburn sheet metal in Auburn Road near Burwood Road in Hawthorn. Nicely done including powerpoint cutouts.

[Bodgy]

Alternatively, if the 'splashback' is only behind the canopy, not the stove you can get great looking laminex which appears identical to brushed SS.

I used this when I did my kitchen (behing the benches) and it looks good. For around the stove I bought a cut to size (and drilled) sheet of toughened glass. Spray paint the back with motor exhaust black paint. Looks great.

[DPB]

Alternatively, if the 'splashback' is only behind the canopy, not the stove you can get great looking laminex which appears identical to brushed SS.

I used this when I did my kitchen (behing the benches) and it looks good. For around the stove I bought a cut to size (and drilled) sheet of toughened glass. Spray paint the back with motor exhaust black paint. Looks great.

Shame to buy a full sheet of Laminex, though.:(

[Sturdee]

Shame to buy a full sheet of Laminex, though.:(

Don, you can buy of cuts and small pieces of laminex from a cabinet maker in Ringwood rather than buy a full sheet. :D


Peter.

[DPB]

Don, you can buy of cuts and small pieces of laminex from a cabinet maker in Ringwood rather than buy a full sheet. :D

Peter.

Peter, please PM me the contact details.