View Full Version : can't answer post
Rod Gilbert
14th March 2016, 07:56 PM
Hi all,
I have been trying to do a reply to a post but can't getting this message.
Your submission could not be processed because the token has expired .n .
Any ideas on what to do I have tried to close the reply window and starting again but same result.
Regards Rod.
Big Shed
14th March 2016, 07:58 PM
Well, you can obviously post on the forum as you just did that.
Perhaps a bit more info would help, eg what post are you trying to respond to?
Rod Gilbert
14th March 2016, 08:19 PM
Sorry about that Big shed this was the post.
WOODTURNING - GENERAL (http://www.woodworkforums.com/f8)
Tormek SVD - 186 inital impression Regards Rod.
Big Shed
14th March 2016, 08:25 PM
OK, I have just replied to that thread as a test, no problem.
http://www.woodworkforums.com/f8/tormek-svd-186-inital-impression-203663#post1938298
I Clicked on Reply to Thread, is that what you did?
Rod Gilbert
14th March 2016, 08:30 PM
That's it Big shed. I go and have another try. I have tried a couple of times before coming here.
Regards Rod.
Rod Gilbert
14th March 2016, 08:36 PM
Went ok this time must have been holding my mouth wrong. Thank you.
Regards Rod.
Big Shed
14th March 2016, 08:37 PM
No worries, just don't hold your mouth like that again:wink: