Reno RSS Feed
6th December 2015, 04:00 PM
For a door which closes inside a frame of width/height W x H, say, and is to swing on "standard" flat-pack Hettich hinge ( Hettich Australia Shop (http://web2.hettich.com/hbh/catalog/Start.do?distributorId=90081&localeId=en_AU&altlogin=en_GB&model=procat_au_530) )
what allowance to leave at side and top? 3mm in total, ie 1.5mm all around?? And if two doors are used, hanging left and right, allow 4.5mm total??
It would be good if it fits!
in hope
Read and reply to the full thread at RenovateForum.com.... (http://www.renovateforum.com/f84/sizing-cupboard-doors-117798/)
what allowance to leave at side and top? 3mm in total, ie 1.5mm all around?? And if two doors are used, hanging left and right, allow 4.5mm total??
It would be good if it fits!
in hope
Read and reply to the full thread at RenovateForum.com.... (http://www.renovateforum.com/f84/sizing-cupboard-doors-117798/)