PDA

View Full Version : Hello From Perth















Alih
28th August 2013, 11:24 PM
Just thought I would say and introduce myself. I'm Alistair and I have always enjoyed woodwork but until recently I had lived in a unit that was a bit small for indulging my passion for building things. Now I have a house, a lot of room and a lot of work to do on the house.

At the moment I am focusing on doing some cabinet work for my lounge followed by a fair few more jobs like it. I discovered this site when I was looking for a solution to a problem. I'm finding it near impossible to square up my sliding extention to my Triton MK3 and hoping to hear of any tips or tricks the brains trust on here might have.

Anyway I'm enjoying browsing at the moment and look forward to soaking up some knowledge and hopefully being able to contribute from some of my own experiences.

Cheers

BobL
29th August 2013, 02:06 AM
Welcome aboard the mad train.

Regards your triton question I would find and post your question in the triton forum where you are much more like to find someone that knows the answer,

JJF
29th August 2013, 06:47 AM
Welcome aboard

crowie
29th August 2013, 08:52 AM
G'Day & Welcome to a top forum "Alistair".
There are quite a few members in & around the Perth..
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP photos with build notes.
Enjoy the forum.
Enjoy your woodwork.
Check out the Triton section in the forum TRITON / GMC (http://www.woodworkforums.com/f15/)
Cheers crowie